Flashing f9 during wash cycle - Washing Machines

Full 'make model (what it is)' and all questions please, first 3 words.

Washing machine displays error message C9 or F9

Electrolux https://www.electrolux.co.uk > support > laundry > wa...
Jun 14, 2023 - Error message C9 or F9 indicates an imbalance during a spin cycle. faulty motor or motor bearings. Was this article helpful?

..

Not knowing what brand / model you have makes it difficult however, the basic symptoms of a water problem are; If the water keeps coming into the machine with the power off and the tap on, it will be a valve fault. If the water keeps coming in with power on and on a wash cycle, its likely to be a fault with the pressure switch, pressure tube (Split or hanging off) or an electronic failure of the control board.Lastly, check the drain hose. If the end of the hose is lower than the water level of the machine, it is possible for the machine to start syphoning itself. Espe3cially just after the first pump out (Start of Rinse cycle) Make sure the machine is actually pumping water out. If it cant pump out, the machine may try to refill but it is already still full from last wash , causing the error code to flash. Check for pump jamming up with foreign objects, or hoses blocked with a sock, lint etc.. Sorry but cant help much more than this.

nordmende dfsn60 error code f9 , the dishwasher is stuck on the 4th cycle but not washing and error code f9 appears how can i fix this

hitachi washing meching not worjing display f9

Have you tried running a cold wash? Could be a heating fault. If it runs a cold wash fine then id go with that as a starting point

Hello,F9 error means there is a problem with the lock switch.Check the wiring to the door lock switch (the wire harness may be connected wrongly).Check for stuck lock switch.
Thanks

Pump is most likely clogged .... take front panel off and pump is right there ......

F9=Overflow Condition
If the Overflow contact on the pressure switch is Closed for more than 60 seconds and Overflow condition will occur. In an Overflow condition, the Door will remain locked, and the Drain Pump will run constantly, even if PAUSE/CANCEL is pressed twice and the Display is cleared. Unplug the unit to service.



Check the drain hose and make sure it is not plugged or inked.

Check Wire Harness connectors to the Drain Pump, Pressure Switch, and Central Control Unit (CCU)

Check/Clean Drain Pump Filter of foreign objects

Check for Drain Pump Failure

Check the Inlet Valve for proper shut off

Check the Pressure switch for proper operation

F9 is a water pump problem, either clogged pump, or pump malfunctioning, Check for something clogging the water pump

also there may be water and air stuck in the pressure switch tip

if this is a fridgidaire washer, I guess it's a clogged coin catcher. You have remove the front access panel and clean it out. I am working on that now.