Describe your Spirit ® XT275 Folding Treadmill Problem - serial number 90488105100032rev-00 I started the treadmill as I normally do by pressing the start button. The belt does not move. I think maybe some kids who were visiting were pushing the buttons? (just a guess) - when I increase the speed to .5 it normally starts. Now when I increase the speed it increases at first then changes to L5 but the belt does not move.

http://www.manualslib.com/manual/263436/Spirit-Xt375.html?page=33#manual

Warrantee and address. on page 33

https://www.google.com/webhp?sourceid=chrome-instant&rlz=1C1GGGE_enUS385US385&ion=1&espv=2&ie=UTF-8#q=spirit%20mfg%20jonesborro%20ak

see the video and proceed according. God bless you

seee the video and proceed according. God bless you

This is probably a 1) faulty speed sensor or
2)the speed sensor is not plugged in properly.
3)Its also possibly a faulty motor control board or
4) lower board. T
he error codes will differ between makes and models but could be e1.
However if you send the complete information, if can not fix you treadmill, how model, mark, serial number, I can handle more specific.
sincerely.
E.CUADRA
MANAGUA, NICARAGUA. C.A

Dear Sir:
Please wathc this videos:

http://www.youtube.com/watch?NR=1&v=USSgbsZbDLQ
http://www.youtube.com/watch?NR=1&v=KiEZDNe0F8Q
http://www.youtube.com/watch?v=wjrVjYe2LYQ&feature=related
Removethe key from the console.

• 2

Unplug the power cord.

• 3

Ifthe walking belt shifts to the left, turn the left rear roller bolt 1/2 turnclockwise with an Allen wrench.

• 4

Ifthe walking belt is off center to the right, turn the right rear roller bolt1/2 turn counter clockwise with an Allen wrench.

• 5

Plugin the power cord.

• 6

Replace the console key.

• 7

Aftera few minutes of running the treadmill, check to see that the belt is centered.If not, repeat the steps.If you need further assistance, please reach me, sincerely G-d bless you.

E.CUADRA
MANAGUA, NICARAGUA. C.A.

hi,
Its time to lubricate your treadmill.
You must obtain the proper lubricant for your treadmill. There are several different types. Contact your manufacturer for what type is needed. Using the manufacturer provided allen wrench, loosen the walking belt approximately 10 full turns on each side of the rear roller. Apply approximately 1/2 ounce of lubricant directly in the middle of the walk area underneath the walking belt upon the deck. Retighten the rear roller 10 turns on each side. Run the treadmill at 6.0 mph for 2-3 minutes to spread the lubricant evenly. Wipe excess lube from the sides of the belt. Walk on treadmill to check for proper tension on belt.
for make it easy for you I have added a video. ok

hi, replace the sensor

If calibration doesn't work replace controller.

Call Spirit @ 800.258.8511.

Any magnet will do. Otherwise order a new one from the manufacturer, other retailer or ebay.