Hitachi projector cp - s210

There is an option in the setup menus to re-orientate the picture, to flip it either vertically, horizontally or both to correct for the various installation options. You should be able to correct it quite easily :o)

Yes possibly because you have done a complete system reset and not a lamp hour reset so you will need to go into image or screen settings and select front view ceiling mount configuration

Hi!

Go to this site to check Manual Online. Click HERE.

Hope this helps.

turn the projector up the other way,

or

Press the Menu button.

Select the Advanced menu. You see the features and their settings on the right side:

Press Enter and use the directional buttons and the Enter button to set the following option:

Projection

Front: Projector is in front of the screen

Front/Ceiling: Projector is in front of the screen, mounted upside-down from the ceiling

Rear: Projector is behind the screen

Rear/Ceiling: Projector is behind the screen, mounted upside-down from the ceiling

hi check the manual here :
http://dl.owneriq.net/c/ca7281e4-c44b-4f8e-8cf0-a138fa0b3e0a.pdf
Please rate me

Yes it should be mounted upside down as you would not want to see the bottom of the projector all the time, unless the bottom is as good looking as the top, which I doubt. I wonder if you bought or got a ceiling mount rack with it. First mount the rack on the ceiling and then fasten the projector to it. And before that its picture has to be turned upside down too.

These projectors are designed to be mounted upside down. Think of a projector that is ceiling mounted in a classroom. Change this setting in Menu - Advanced Menu - Setup - Mirror.

You should go to the menu and look for the "Mirror" settings, change the vertical to bring it rightside up, however if it is also backwards (horizontally) change the horizontal "Mirror" there is an option of turning on either both or each separate option. I assume though that you will probably just have to change the setting to H&V Mirror.

Yes, this unit is made for either or solution. If you look at the under side, you will see three screw holes, these are for your mount kit which you can get form http://www.mountsandmore.com/Projector-Ceiling-Mounts-C13810.html?refid=G6435.%22projector+ceiling+mount%22&gclid=CIyfl7G_2pgCFQEoGgodXmajdw

There are other sites as well.

Hope this is not too late.

i have a vpl-vw10ht projector and iv put it to ceiling but the picture is upside down what do i do