Player won't open. how do we reset?

Sounds like the power supply in the dvd player has failed. It works just well enough to turn on the led infront but as soon as you go to do anything it shuts off. This is common in cheaper dvd players. Unless you can troubleshoot electronics. Or know someone that can. Your best bet is to unplug the unit and disassemly and retrieve your dvd.

press stand by and press return button and enter button and then press stand by button on ur remote control.the player will be unlocked

It is most likely a burnt out capacitor. It is probably the capacitor on the power supply and it will need to be changed.

Hit the PSCAN switch on the back of the unit.

I had same problem with JVC player. Found out from manual that there is child lock- activated by pressing stop + eject when unit in stand-by mode. (which I must have done accidentally) Unlocked by repeating action - in stand by mode.

I can't get the tray to close

usually the cause of error is defective cd lense. the best thing to do do is to replace your dvd player with a new one

Unlike the suggested solution to reset to factory settings by pressing the stop button on the DVD player itself with the tray OPEN, in my case I succeeded only with the tray CLOSED (no DVD inside). The light flashed to red e back to green and it was done.

I had the same problem, After googling for a few minutes I found the reset procedure for this player.

1. Turn it on.
2. Eject any disk you have in there and close the tray.
3. Hold down the "STOP" button on the player (not remote) until the green light flashes red and the system reboots.
4. Insert disk and enjoy.

This worked for me... mileage may vary.

Hi kjflynn06 let your DVD player stand for about 2 days then you plug it in back if that does not work call a tech could be a faulty power supply good luck.