Projector screen turns off after 10-20 seconds

Yes please call me Just went thru the same issue with my customers projector it involves more then typing can fulfill. Thanks Jordan Thomas

910 538 2754
PORT CITY AV

I believe that's an overheat problem. Check the fan if it's cooling properly. Make sure the unit is in a cool temp room.

reset the lamp timer. unplug it and plug it back in. hold down the enter, down, and menu buttons, then press the power button.

Hi
This would be "Standby"
When you press standby, the display and audio turn off and a blank screen is displayed for 15 minutes.
You can change the amount of time the projector stays in standby mode; see “Standby Time” on page 27 for details.
The LED lights orange while the projector is in standby.
• If you press standby again within 15 minutes, the projector returns to normal operations immediately. The LED changes from orange to green.
• If you press standby again after 15 minutes, there is about a 60 second delay before the lamp turns back on. The LED flashes green while the lamp is re-lighting.
• If you don’t press standby again, the lamp turns off after 15 minutes. The LED lights orange while the projector is in standby.
The full manual can be found here:
Infocus customer support
Infocus LP350 Manual
I hope these help
Mike

I have 2200MP projector that when you turn it on,it clicks about 8 to 10 times and then the power seams to turn on, but the lamp light light comes on and nothing lights up. it will shut down after that, with the green light still flashing. What could be the problem? Roger

Hello,

1. Pls check and inspect the Lamp unit.

2. If Lamp unit is okay, Then the Problem is with
either with Ballast unit or the DMD Module.

Regards

Viren

try pressing and holding the enter button on the projector for about 30 seconds - this resets it. It worked for me!!

Thats the projector telling you that you need to replace the lamp. Lamps usually lasts for about 2000 hours so if you had it for a while you may need to replace it.

www.froogle.com and enter your make and model or go to www.projectorcentral.com and find a few retailers in the US that sells lamps.

good luck

smeags

Hi, The owners manual says that if the red light is flashing, it is an indicator that it is ready to be turned on (use remote or onboard on button); flashing red & green - too high temperature inside, the unit is overheated. Check and clean the air filters; If the red light is steady, abnormal condition and you have to call for service. A copy of your manual is available at http://www.eiki.com/resources/resourcedownload.ashx?filename=/ownersmanuals/om_xb25_20_sb20.pdf Hope this be of some help. Pls post again how things turn up. good luck and kind regards.