Bottom left lights. when i turn on tv red light flashes what does mean

It may be the lamp light indicating a lamp has failed--model listed here does use a lamp.

Also look at the blinks to see if a specific number then a pause and repeats, if that then that is a error code.

send me a email [email protected] and I can assist you with troubleshooting it to determine whats happening with the set.

When the battery is almost empty (when there are only 5 or fewer shaving minutes left), the battery symbol lights up red.

Make sure that the battery does not have a memory effect. What I suggest is taking the shaving head unit off and running the shaver till empty, then recharging. Check if the red light is still flashing.

There's also a head indicator at the bottom of some shavers.

To remind you to replace the shaving unit, the shaving unit symbol flashes (all types) and you hear a beep when you switch off the shaver (RQ1090 only). This happens at the end of 7 successive shaves to remind you to replace the shaving unit.

Without knowing what model you have it's difficult to diagnose further.

I need a model or chassis no. (on the back of the TV). Also how many times does the light flash between the long pauses? Sonys have a self diagnostic feature that flashes the power light a certain number of times to indicate various problems.

You have to bad compacitors on the power board. They will be buldged on the top. Once replace you TV will live again. The parts will cost you about $4

red light flashes 4 times then stays on for about 5 seconds then flashes 4 times again any idea what this means and how i can fix it tv is about 4 years old and only just started doing this

still nothing, tried twice last night and second time tv worked, this morning nothing

got a replacement TV

The problem is the black screws on the bottom of the frame that screw into the X-Clamps. Most of the time, you usually don't have to even put the black screws back in. However their can be exscruciating headache inducing problems with fine tuning the black screws. If you do end up needing to put the black screws back in, I suggest to start with one @ a time, starting with the bottom right screw. ( thats with the 360 standing vertical with the dvd drive faced toward U.) The tightness can range from almost as tight as you can possibly get to soooo!!!!!! loose u can't possibly imagine how its doing anything at all. The best way to do this is, with the 360 hooked up, (and the case left off) take the small white plastic frame off that covers the power button, start with the screw loosened and then proceed to turn slightly like an 1/8th of a turn, then power on and then turn off if 2 red or 3 red ring proceeds and then repeat. You shouldn't have to put all the black screws back in, mine only has bottom right bottom left and top left, and are incredibly loose. My friend however has bottom right only and is tightened only about 1/2 way.