Yamaha receiver RX-V663

Make sure none of the buttons are stuck in. One button being stuck may make all the others not work.

Digital settings need to be assigned by the receiver in the ption Menu >> Audio Select.

Check the one for the HDMI from DTV/CBL.

The RX-V365 cannot process audio from the HDMI cables (you will still be able to hear it on your TV), you will need to run a seperate coaxial or optical cable into the audio input for the relevant component on the back of the RX-V365.

Inputs on your receiver are assignable. Assign one input to DVD function and other input to DTV/CBL for example. Refer to page 49 of your manual for instructions.

Check the setup menu of the receiver on zone 2 settings most likely the error is a fixed volume setting for this zone. If not found, reset factory settings and try to setup everything again. If the problems persists, contact your vendor if still under warranty.

I had the same problem with RXV3900, was told by verizon and yamaha it's a software issue with the box. Verizon is suppose to be working on a new update, but no time frame for now. I'm using component to receiver, and hdmi to tv with no issues.

To get audio with this set up also hooked up analog audio RCA cables for the audio for each piece of equipment for 2 channel out put. Zone 2 will not out put a digital signal and this receiver will not down convert a audio signals to analog if using digital audio hook-ups.

Most likely you have pressed the speaker AB switch, try pressing it again and see if it works.

Hi and welcome to FixYa,

Initially, a workaround:

• as you posted, audio out of the DVD goes to the receiver;
• HDMI out of the DVD goes to the Schaub Lorenz LCD.

Even if it were a compatibility issue or HDMI processor issue on the receiver, the above should get you going.

Good luck and Thank you for using FixYa. Happy Holidays.

Check if DTV/CBL is set receive COAXIAL or OPTICAL inputs. Good luck