Turn off elapsed time in Yes PDV-102CRT - Yes PDV-102CRT Portable DVD Player

Code

C-2302

Description

The EM signal shows an abnormal condition when a specified period of time elapses after the cleaner cooling fan (FM5) turns ON. This abnormal condition recurs when a specified period of time elapses after FM5 is turned OFF and then ON again.

Causes

Cleaner cooling fan (FM5) ADU drive board (ADUDB) Printer control board (PRCB)

Yes on some vehicles you have to leave the ignition on. If you turn off beforehand you must wait all over again. Will ask you for a code normally after this time has elapsed.
Good luck with it.

go to your color in settings on remote and turn the brightness up a notch not to much just a notch.

Usually suspect condensation problem, let it dry out and try cd first.White screen maybe contact resistance in the connector due to condensation from room humidity.

Yes that's elapsed time from when you turned on the ignition. Press the black button underneath the display to change mode to outside temp or mpg or miles to empty......We've got the 05 Legacy 2.5i with the same function/display......

C1183
Elevator motor ascent/
descent drive failure
• The elevator tray lower limit sensor (PC13) is not turned ON
even after the set period of time has elapsed after the main
power switch is set to ON.
• The elevator tray home position sensor (PC11) and elevator
top face detection sensor (PC12) are not turned ON even
after the set period of time has elapsed after the elevator
motor (M11) is energized.
• The elevator tray does not stop at the position for the specified
tray after the elevator motor (M11) is energized (beginning of
descent operation) and the elevator tray lower limit sensor
(PC13) is turned ON.
• The elevator top face detection sensor (PC12) is not turned
ON even after the set period of time has elapsed after the elevator
motor (M11) is energized (beginning of ascent operation)
when paper is being fed out.

type mismatch error occours when there is a mismatch between the value which you are trying to assign to a variable which is dimensioned to store values of another, first you check if the datatypes match each other by applying the break.

what operating do you use?