Need login and password for a Zhone router/modem Model #:6218-I2-200-0CC.

admin=username

cciadmin=password

for advanced users

Hi!

Please follow the guide here... It's for a different Zhone model - but it should work exactly the same!


In case of a problem or clarification, don't hesitate to post me a reply before rejecting my answer.
If you are satisfied, rate my solution with the "thumbs" or (even better) add a testimonial.

Best regards,
Pelu.

Usually for all routers the default pass and usrer are admin/admin. It should be the same with your router.

YOU CAN RESET THE ROUTER TO FACTORY SETTINGS
You may reset router to factory setting from the reset button on the back side of the router. Use a paper pin to press the button for few seconds, the lights on the front would blink and the router would restart with factory setting. Please not that ALL SETTING WOULD BE LOST...AND YOU WOULD HAVE TO MAKE CONFIGURATIONS AND SETTING ALL OVER AGAIN

Here is the link to official Zhone support site for further detail (if required)
HOPE IT HELPS...Let me know if you need any further assistance
CreativeTECH

2 ways you can do this. <br /> 1. Connect to your router 192.168.1.1. Go to advance setup, NAT settings, then virtual servers. Click ADD, you will be at a setup screen now, click Select Service and choose xbox live. Then type in your ip address just below (192.168.1.1) and click save/apply, thats it.<br /> 2. Go to this site, <a href="http://www.portforward.com">www.portforward.com</a>, go through the motions and selct your zhone 6218 modem. Follow the directions they have listed.

try doing a Google search USUALLY the address is 192.168.1.1 if your running xp or higher look for the command prompt icon it is in the start menu under acessorys the type ipconfig it should give you a number for your gateway or call up the manufatures tech support

use the xbox recommended router going to this modem it will work

To restore the router to factory default settings, select Management ->
Settings -> Restore Default.

I take it that is what you have tryed?

http://zhone.com/support/downloads/cpe/

try finding the correct firmware to install

The manufacturer won't have your installation CD because that process is exclusive to your ISP. Check your ISP's website to see if they release their setup software online or contact them to get the required CD.

The user name : password is normally admin : admin

To reset the router try holding the reset button on the back of the box for about 10 sec. (make sure the power is on while doing this)