Appliance rewiring wiring WIRLPOOL ULTIMATE CARE II

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

most of the time coupler will be fine. but it could be broke b/c of tranny. spin by hand make sure tranny will spin freely both ways. make sure it adjitates and spins. then replace coupler start it up. the good thing is that a coupler is cheap so if it ends up being bad you didnt spend much anyways.

Check this out

Bonus


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Even a gas appliance needs electricity to start etc, so if you have that setup i reckon it must be gas? If the gas bottle hose goes into the unit, then YES.

The timer cam is not aligning the internal switches. Replacing it is the only fix.
Eric

does dryer heats up if yes take hose out from back of your dryer run dryer if you have good power air coming out from your dryer i think your dryer is fine you need to clean your air vent. system.

also,shorten front legs,lean washer forward,and reset back legs.level.

Belt needing to be replaced is obvious.

As for a schematic of the motor, I think what you are really needing is a wiring diagram and schematic of the complete washing machine. Most often, there is a paper one glued to the inside of the removable panel on the back of the washing machine. Either there, or inside the control head on the top of the washing machine.

Please include the specific model number in any replies.

replace the direct drive coupling part number is 285753
i can tell you how