New IT this was settup by old IT don't know passphase but never the less can access internal network but can not access internet. AP is not connected directly to gateway put wired on the internal network. I know this at one point worked but does not now. Not sure how to troubleshoot call Trendnet 3 times still waiting for Level 3 reply. Any suggestions? Doing a power cycle is not a solutions that I can do would require powering whole network which is not an option.
If you press the reset button at the back holding it in for about 10 seconds, that should set it back to it's default. Then in your address bar log back into it. The default username is usually admin and sometimes the password is admin too. If not it's either password or there is no password so you can just press enter on your keyboard. This way you can set it up the way you want to. Just be aware that if you use WEP 128 bit, you have to have 26 characters as a password. If you use WPA PSK then you only need 8 characters. You should be able to access this from the word wireless in your options list. I would run the setup again first and then do all the configuration next. Lets hope this helps you out.
718 views
Usually answered in minutes!
Problem was solved thank you for your help solution was using a static IP on workstations for wireless connection instead of using DHCP not sure why DHCP didn't work on the workstations.
×