What kind of rechargeable battery goes in the Kodak Easyshare Z710?

Question edited for clarity. Your camera is a Z710 not a 2710.

Drivers and software.

Kodak EasyShare Z710 Digital Camera Software

https://www.kodakdrivers.com > kodak-easyshare-z710...
Mar. 15, 2017 - Kodak EasyShare Z710 Zoom Digital Camera Software, Driver, Firmware and Share Button software download for Microsoft Windows and Macintosh ...

Kodak EASYSHARE Z710 Software Download - Digital Camera

https://www.helpowl.com > Kodak > Z710 > Research
Appendix Upgrading your software and firmware Download the latest versions of the software included on the Kodak EasyShare software CD and the camera ...

Kodak EasyShare ZD710 Software Downloads

https://www.kodakdriver.com > kodak-easyshare-zd710...
Apr. 11, 2014 - Kodak EasyShare ZD710 Zoom Digital Camera Software Driver and Firmware for Operating Systems. Kodak EasyShare ZD710 Software Downloads ...

You can use two AA batteries OR one CRV3 battery. A CRV3 is nothing more than two AAs stuck together and go where two AAs go.

Refer to the illustrations on
http://resources.kodak.com/support/shtml/en/manuals/urg00576/urg00576c1s3.shtml

The Z710 uses standard AA batteries, disposable or rechargeable. If you want to use rechargeables, you should be able to find battery chargers at just about any department, electronics, or office-supply store.

Here are the steps:
1. Make sure you will install a new or fully charged battery/batteries into your camera.Pls. use lithium batteries Ni-Mh or rechargeable Batteries (2000 M.Amp or higher).
2. Clean the battery contacts.
a. Remove the battery/batteries and the memory card from your camera, then wipe the battery contacts with a soft, clean cloth.
b. Reinstall the battery/batteries into your camera
3. Without the memory card,turn on your camera.

Contact KODAK:
http://www.kodak.com/eknec/PageQuerier.jhtml?pq-path=14563&pq-locale=en_US&_requestid=3490

Pls. use lithium batteries Ni-Mh or rechargeable Batteries (2000 M.Amp or higher).
Battery support : KAA2HR,CRV3, 2xAA Ni-MH and 2xAA Lithium-Ion

Make sure that you are installing a fresh/ full charge battery
Remove the battery
Clean the metal contacts on the battery using a clean cloth

Contact KODAK:
http://www.kodak.com/eknec/PageQuerier.jhtml?pq-path=14563&pq-locale=en_US&_requestid=3490

The first thing to do is check the battery contacts inside the camaeras battery compartment. Make sure they are not dirty or corroded and clean them if necessary. I have seen this problem with other models of the EasyShare wher users have used normal then rechargeable batteries that have effectively squashed the battery contacts so when then went back to using normal batteries they did not fit correctly.

I went ahead and looked this up for you. Kodak says you need a Li-Ion Rechargeable Digital Camera Battery KLIC-7001.

You had the right idea, but the wrong number. Hope this helps.

Some cameras can be used as a webcam, however i dont think Kodak thought this through and therefore did not provide software for webcam on the cd.

Pry the battery contacts " in bottom of camera" up GENTLY" with a small flat head screw driver. They bend easy causing this problem. The force from the battery door can cause this. Always use the "rechargeable" batteries, and make sure it is fully charged. I'll bet anything it will work then. Also. clean the contacts top and bottom with a Q-tip, using a little dab of white vinigar on one side, then dry using other side of Q-tip.Then turn on camera without memory card. Kodak cameras love to eat batteries. The older they get the worse. You might have to repeat this every week or couple of months.

Kodak custsomer support
It is likely the only real answer is to replace the camera
These thing dont get repaired usually.