Zanussi ZSF 6161 Dishwasher error codes

Hi.
This sounds like doorlock issue.
You can access it from the door panel.
Panel has 4-6 screws.
From there you can check it with a multimeter (ohm setting).
It could also be as simple as bent door hatch, door lock not engaging with doorlock.

Did you try a hard reset

remove clip best to replace with jubblie clip

follow this steps and fix it. God bless you
Check Power
Check the outlet by plugging an appliance into the same outlet the washer was plugged into an running the appliance a hair dryer works good for this it will draw some amperage. If it works fine move on.

Control
To check the control remove the top panel and then remove the console to access the wiring to the control. Find the wire feeding the control from the main power cord. If you cannot visually see this refer to the tech sheet or service manual. Connect voltmeter to the 2 wires feeding the control if it is recieving power and it does not respond replace the control

see your instruction manual, and go to the section troubleshooting.
however is very simple, unplug the power and proceed taking the first wire and make note for color wiring, and replace.
If you do not i.manual download from www. retrevo.com
God bless you

measure the heating element resistance it should be around 25 ohm.
otherwise it is the problem.

You can replace the relay, sometimes it stop working with no external damage signs

CHANGE YOUR SWITCH ASSY (DOOR LOCK ASSY)01179512835

I have a Zanussi Jetsystem Progress ZSF 6161 Dishwasher stops after a few seconds and flashes -30 Any ideas? thanks!

The light cover on the side is loose causing it to flood remove the side and tighten the light cover the tilt the dishwasher to get water out of the float tray. let the dishwasher dry out and you should be grand

You can check the heating element with an ohmmeter and it should read a few hundred ohms. Don't know about the thermostat but it should be inline electrically with the heating element and should ohm as a short when cold.