M7310 doesnt page when i press page button - NorStar M7310 Phone

I guess you want a page key programmed on your set. press feature *3, press a memory key, press feature 610. This key pages all sets when pressed.

Most likely you can swap the phones. On older systems it might not work so I would try one first. You do gain extra buttons which can be programmed as desired. Any buttons you had on your M7310 would be on the T7316e. You can check the buttons by pressing Feature *0 this will allow you to check any button on the phone.

On each phone, press Feature *1 and the OK soft key. This will clear the button.

Hi

To Turn On or Off Do Not Disturb:

1. Press the DND key or press the Feature button, then 85

2. To turn it off: Press the DND key or the Feature button, then #85

Thanks

It sounds like although they're labeled as line buttons actually they're programmed as station buttons.
If you press feature *0 and one of the buttons it will tell you what the button is programmed as.
Also did you try pressing the intercom button then dialing 9? that might be the way the set was programmed.

If the extension was a swap of the old M7310 with a new(ish) M7310 no additional programming should be necessary. However if the phone was replaced with another type of nortel set(M7208, M7324,T7313 etc.) then the phone will default to its base features. To re-program the feature keys press feature *3, the button you wish to program, and the feature code for that button

If you are asking about Outside Auto Dial numbers (a "speed dial" number programmed to a button), follow these steps:
1. Leave the handset down
2. Dial "Feature (star) 1"
3. Press the button to be programmed
4. Enter the "speed dial" number
5. Press button under "OK" on the horizontal display.

The group of 12 buttons on top of an M7310 phone are Dual-Memory buttons, each can hold 2 speed dial numbers. When you press the button, you are using the Lower Memory location. When you press the Shift button (triangle-shaped button on the right) and the a Dual-Memory button, you are using the Upper Memory location. Good Luck!

First try this. Press FEATURE 601. If that pages all speaker, then I remembered it correctly. If not, Try 6xx 602? 612? until the display says PAGE ALL. That's the feature code.

Now, pick a button. Press FEATURE *3 the button and dial FEATURE 6xx with xx being the code you used above.

Now when you press that button, it will page as you desire.

Carl

buttons not setup for c.o. access.Try dialing 9.

Ok ~ I need you to goto the phone, dial FEATURE * 0 (this shows you what is on all the buttons on the set) and press the page button...
It should display F631 if it says anything else, that is what the button is...

Ok, so, to change the button back to page...

-> press FEATURE * 3
-> press the button for Page
-> press FEATURE 6 3 1

Voila, you have now programmed the button to page once again.