Kenmore Progressive 335

Since it's a Kenmore unit, you can find the Owner's Manual online at a Sears Parts Direct.

Thanks for choosing FixYa.

Hi and welcome to DixYa, I am Kelly

The only two parts requiring any service are the activated carbon pre-filter and the HEPA filter. No tools are needed. To change either filter, disassemble the unit as shown.
1. Loosen the carrying handle by turning it counterclockwise and lift filter cage cover from unit.
2. Lift HEPA filter and activated carbon pre-filter from the base.
3. Remove the fasteners from the activated carbon pre-filter and remove it from the HEPA filter cartridge.
4. Replace filter(s) as needed, and discard used filters.
5. Wrap the activated carbon pre-filter around the HEPA filter cartridge and secure it with the fasteners provided

Pictures are here:
http://www.american-allergy-supply.com/hd/hwc.htm

Thanks for choosing FixYa,
Kelly

According to the Owners Manual, here's what you need to do,

1.Turn the air cleaner OFF and unplug it from the power outlet.

2. Carefully lay the unit down on a flat surface with the Front Grille facing up.

3. Gently push in on Release Buttons on both sides of the unit, pull Front Grille out and away.

4. Remove and discard used HEPA filter.

5. Remove any plastic protective wrapping and from the new HEPA filter.

6. Set new HEPA filter into the air cleaner.

7. Install the Front Grille by engaging its tabs into the bottom slots on the unit. Then swing grille up and gently push in top to snap into place.

8.Turn the Air Cleaner upright and plug it into an outlet for
operation.

Hope this helped you. Please let me know. Thanks

Have you looked at Sears' online parts store? Type in the model number, and it will display available replacement parts.

http://www.searspartsdirect.com/


You can also get there from the Sears home page:

http://www.sears.com/

Click "parts direct" at the top of the page.

Buy online at:

http://www.searspartsdirect.com/


You can also get there from the Sears home page:

http://www.sears.com/

Click "parts direct" at the top of the page.

Yes. You will have a prefilter and after that you will have a HEPA filter. Keep good maintenance on the prefilters which are not washable. You will need to check it once a month to see if it is time to replace. If you have good maintenance on the unit and change the cheaper prefilter, you will get years of service out of you HEPA filter. Bad maintenance means replacing the HEPA filter which is a good chunk of the cost of the purifier.

there should be a directional arrow to show which way air flow should go, if its framed it will have a pull tab that goes facing out, if it a piece that looks the same on both sides, it can go in either way, if it has a white side it goes facing in

Hi, are you sure about amazon?! I found your part there for 15$ (less than your budget of 25-30$). Take a look again here:
Amazon com kenmore charcoal filter. I hope this was helpful. Cheers

http://13520-replacement-charcoal-pre-filters.com/honeywell-enviracaire-hepa-air-cleaner/

Filter lights on your Air Purifier http://www.fastbrowser.net/netpicker/Filter-lights-on-your-Airifie.htm One of the best things about your IQAir Air Purifier is that it has warning lights to tell you when to change the prefilter, gas or hepa filters. Of course how long they last depends on your pattern of usage. For the initial 80% of the filter life the control panel will display a green light next to the corresponding filter on the outline of the unit. When the orange light goes on it does not mean that the filter needs to be replaced immediately but that there is 20% of useful life left. IQAir gives you plenty of time and the machine will tell you how many hours you have left. Once the number of hours gets to within a few hours remaining the orange light will then change to red. It is at this time you should change the filter. If you forget to change it and there are no hours left the hours will go into the negative displaying how many hours you have gone over and the red light will change to a flashing red light.

Just in case you have lost the manual like one of our customers, this is how you reset the filter lights:
1. Press the menu button ( 7 times) until you get to where the display says new filter.
2. Press the enter button and hold it down for 3 seconds and a number 1 will be flashing after the words new filter on the display. This flashing number is so you can enter which filter you have changed. Filter number 1 is the pre-filter, filter number 2 is the V-5 gas filter, and filter number 3 is the Hepa filter.
3. You change the number for the filter by pressing the up arrow button.
4. Once you reach the correct filter number you press the enter button and the control panel will display a question mark after the words new filter on the display. Below this it will say, E = Yes M = Cancel. If you wish to cancel the entry so it does not reset a new filter life, simply press the Menu button.
5. If you want it to reset the filter life for the changed filter, simply press the Enter button. Once this is done, the filter light will change back to the green light, which will show the filter has been changed. If you go to the remaining filter life on the control panel for the filter number you just changed, you will now see the remaining life of the filter in hours has been reset.

When most people think of Oreck, an air purifier is usually not the first thing

IQAir Dental Series Air Purifier

UV air purifiers are very effective at neutralizing airborne pathogens

HEPA Air Purifiers

REPORT ON THE AIR QUALITY CLEAN UP IN OUR OFFICES

Ozone Air Purification

Ionic air purifiers come in three different forms

WHOLE HOUSE HEPA

Dehumidifiers - Ebac Orion

Furnace Filters, Electronic, Electrostatic Air Filters - Comparisons, Ratings,