Hi, Expert Guy , I have some problem with Panasonic TDA100 about calling Out by co line i have 20 extension and 4 CO line , so when i need to call out , i press number 9 , it will switch to the line free . but i don't need it . when i press number 9 to call out , i need it to switch to the Co line that i want . So how can i do it? Please Help me

make sure that your service provider has installed 3 individual lines into the building
check that the 3 incoming lines are not all together in the plug at the wall
you may need a telephone technician to check it out

Two possibilities. The C.O. is not sending a disconnect or the timing needs to be set. It's a C.O. trunk time you adjust first and if that doesn't work, call the telco. We have hardware to simulate disconnect supervision if the phone company (or PBX extension like a Panasonic) can't provide it. We have to use them on elevator extensions.

Carl

A Panasonic Analog PTS ring sound is not adjustable, however, the cadence is. An outside call rings with a single ring, an internal call is either voice announce or a double ring. The digital phones from Panasonic have either 8 or 30 different tones, but that's a different system.

Carl

No. At the very minimum, you need to go to program 400 (3.3 in the U.S. Maintenance Console) and turn on the lines. Access may have to be enabled from each extension for both outward and ringing programming might have to be added.

Carl

Whenyou program the buttons use the following steps -
press PROG
press the BUTTON to store
press 1 for an extension and the enter the extn no. followed by STORE
(or press 0 to store a line key)
(or 2 to dial an outside number dont forget a 9 for outside line access)

I just now realized that your TDA-100 is not correctly wired or set-up. You'll need to call the installation company that put it in. What you want: Is to have CO lines 3 and 4 to be accessed by extensions; 101, 102, 103... and CO line 2 to be accessed by extensions: 104, 105, 106, 107. CO line 1 needs to be dedicated to a particular extension; More than likely in your office. And then you would not have to dial 9..just pick-up and dial the number. Please stay in contact until we resolve this nasty trouble.

Master [email protected]


I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

you will still need to dial a 9 from the phone to get an outside line, or you can program the analog ext to auto dial it for you. If you still can't then it sounds like the phone is in the wrong COS so it doesn't have access to the CO's.

With one CO line you can only make or receive one external call at a time. You can have extensions connected on intercom calls, but once your CO line is in use, anyone calling in will get a busy signal, as will anyone in the office trying to make an outside call. You'll need additional CO lines if you want to have several outside calls going on at once.

i will making tda-200 ext and co lines cable