The screen was unplugged and now when plugged in the blue light around the power buton just flashes

Question edited for all the typos.

This page of the manual.

https://www.manualslib.com/manual/1755970/Graco-Sense2soothe-With-Cry-Detection-Technology.html?page=39&term=blinking&selected=1#manual

It appears to be a known issue. You may have to contact Graco direct.

https://www.google.com/search?q=graco%C2%AE+sense2soothetm+swing+flashing+blue+light&

..

A bit vague? Unplug, remove battery, leave battery out, plug in , push the on/off button. Describe what happens, fan spins? LED's blink? HDD spins up? Sound? Any thing on the screen?

unplugged the tv for a while then re plugged it and power it on, lets see weather it works normal. if doesn't work unplugged it again then remove the rear cover then look for a bulging capacitors in the power supply board.

I think there is a problem with your battery, check this.

1. I unplugged the power cord for 20 seconds
2. Hold down the # and 6 keys together and then plugged the power cord back in and hold those keys for at least 10 seconds.

unplug it and press the power buton and then hold the power button, and while your holding the power button, plug it back in

hope it worked!!!

it sounds like a capacitor blew from the inverter board.. if u can open it it should be obvious which one the messed up..

Hi

Try resetting the printer

POWER DRAIN:-Turn off the printer, Unplug the power cable from printer and from the wall outlet.Press and hold ON buton for 30-60 seconds.


PARTIAL RESET:-Unplug the printer power cable while its ON, press and hold # and 3 button and connect the Power cord while holding.Wait untill the ON light flashes, then release the buttons.

----(for below reset cartridges must be removed out)---------

SEMI_FULL RESET:-Remove the ink cartridges, Unplug the printer power cable while its ON, press and hold # and 6 button and connect the Power cord while holding.Wait untill the ON light flashes,or wait for 20 seconds,hen release the button.If the printer goes off dont worry release the button and Push the ON button.


FULL NVM RESET:-Take the Ink Cartridges out, Unplug the printer power cable while its ON, press and hold OK and CANCEL button and connect the Power cord while holding the buttons.keep Holding the buttons until the printer goes off ,release the button and Push the ON button.

(Notes - resets will take a while)

Thanks
Riz

hey
the pass code for BT-020C is 1234

i fixed this problem by unplugging the monitor, unplugging the video cables. Then hold down the power button while plugging it back in. Release power button and then press power button for on. It worked then. I got the icon for no signal, i plugged back in my monitors. Sceptre X9W