Konica minolta bizhub 162 have error C0000(main motor malfunction) i try with another motor but same thing! any ideas?!

There is no 'ee102'. Call for Service.

C5102
Description: Main motor malfunction • The main motor (M1) lock signal remains HIGH for a continuous 1-sec. period at any time 1 sec. after the main motor has started turning.
Causes: Main motor (M1) Printer control board (PRCB) DC power supply (DCPU)
Remedy: 1 Check the connector between M1-PRCB CN6 for proper connection and correct as necessary. 2 Check M1 for correct drive coupling and correct as necessary. 3 M1 operation check. PRCB CN6-7 (LOCK) 9-D 4 Change PRCB. 5 Change DCPU.

CC102
Description: Controller - engine connection failure • The engine control system can not communicate with the controller.
Causes: Printer control board (PRCB)
Remedy: 1 Turn OFF and ON the power switch. 2 Change PRCB.

https://www.google.com/search?q=Konica+Minolta+bizhub+165e+error+code+ee102

..

The code means there is some problem that requires a service technician to solve.

main motor

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Main Motor failure check the image unit and or the paper draws or you have a bad motor worse case the main control board

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Fusing Cooling Fan Motor malfunction

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Code

C5102

Description

Main motor malfunction
- The main motor (M1) lock signal remains HIGH for a continuous 1-sec. a period at any time 1 sec. after the main motor has started turning.

Remedy

1 Check the connector between M1-PRCB CN6 for proper connection and correct as necessary.
2 Check M1 for correct drive coupling and correct as necessary.
3 M1 operation check.
4 Change PRCB.
5 Change DCPU.

I’m happy to assist further over the phone at https://www.6ya.com/expert/latoya_8ed1bf3dc615c15d

Error code c0000 means imaging unit drive motor is not working or imaging unit get hard so its better to call a service representative.

Main motor malfunction.Change the main motor and check the fusing unit.For reset turn OFF and ON the power switch,unpluged the cords and wait 10sec. pluged on and then ON the power switch.

tenho um problema de paper ja open 1st side cover,m o que fazer

I have just setup DP-300U rev.B1 with my Konica Minolta Bizhub 162, the thing is that it doesn't work with USB port connected (paper out), then I tried connecting Bizhub 162 to LPT port, and it works just fine...