Roland fantom -x6 freezing

Your best bet is to contact Roland Support. Here's the link-

Roland Company Contact Us Contact Us

Contact Roland directly. Speak to their customer service department in your country. I beleive this is the info-
http://www.dealerlocations.in/roland-dealers-in-kolkata
If it's just a parts availablitiy problem, remember that Roland is a world wide company. Contact Roland in other markets, starting close to you and expanding out. Somebody will have it. I'm in the USA and often source parts from Canada, for instance.
If the instrument is truely dead, you can always sell it for parts to other users. Ebay would be a good option.

I need fantom x6 motherboard!!!
My whatsapp no +91_9760504606

Does the headphone jack work? Replacing a whole board would be expensive and the problem could be elsewhere. What was the accident? If large signals were driven back into the audio out lines, probably the output driver chip is fried... They likely use a common 8 pin dual op amp as the driver and the part costs 50 cents. It takes a little care to replace it as it is likely surface mounted. I am looking at the audio/jack board for a G-600 and there are a pair of transistors for some testing they do that could also be fried and might be the whole problem if the G-6 uses same or similar circuitry. The Fantom X6 uses very similar circuitry... Download service manual here:

http://elektrotanya.com/roland_fantom-x6.pdf/download.html

Scroll down to "get manual" and click to download. IGNORE other download links. On page 57 of 66 you will find the audio drivers at the right. They use little dual op amps M5218APF which probably are available someplace, however probably 4568's would work fine and are readily available. If you drove high voltage into the audio outs, I suspect first that the RF bypass caps such as C203 on the above schematic shorted. Simple to replace... pennies apiece... The test path transistors such as Q37 may also be shorted... Next would be IC18... While this circuit may not be the exact one for the G6 it probably is CLOSE as the several Rolands all seem to use similar circuitry. Regarding system SAFETY... Make sure ALL and I do mean ALL equipment interconnected including mixers, powered speakers, keyboards, etc. are powered from the SAME receptacle or power conditioning module to avoid accidents. Also for keyboards sent to mixers, USE DI boxes please! These protect against ground loops and these accidents.

If you hook it up with the USB cable Logic should recognise it. You may have to select it in the Audio Preferences as your Audio Interface.

when i turn on my roland xa it's going on but it show on screen xa fantom and it gonig hang what i do

It obviously will need to be repaired. It sounds like a power supply problem. I would NOT use it until it is repaired as there could be a problem that if left untreated may damage other components.

Some devices go into a sleep mode if no action is being done, but it doesn't sound like that is the case with your unit.

This is NOT likely to be a problem with the power source at all but more likely with some setup parameter. Search your manual for subjects like "quantize" and also sampling rates.

Contact Roland directely about it. Never trust dealers... they are take an asprin and call in the morning put-offs...

The button probably has a contact problem.

Try looking here to see if you need an update:http://www.roland.com/products/en/_support/dld.cfm?PRODUCT=FANTOM-X6 If you are using bigger samples you may need a memory expansion.