I have a dlink wbr-2310. My wireless works, but only after a fashion: it seems like whenever I want to use the wireless connection, I have to connect to the router console and simply go to the wireless settings and save them again. The router restarts, and the wireless connection is good. Next day, I have to do it all again. Why doesn't the wireless connection work without me having to do this?

There is a great article at Working with Windows Wireless Networks
If you need more help post back! Thumbs and testimonial are welcome!

connect your computer to the router by an ethernet cable. Open Internet explorer or FIREFOX. Type the roiuter's default IP-address (if not known: its either 192.168.0.1 or 192.168.1.1 or 192.168.0.0 or 192.168.1.0... keep trying until you're answered and asked for the password to enter the router (either attached on the router, in the manual or try: user: admin password: admin or password: password. Whgen you're in you'll find many checkboxes you could fill oput or notr; Easyway: give your net a name (SSID), then choose the network access security (set it to wpa-psk), choose a password and enable DHCP (then the router does the rest). Disconnect, look if the computer sjhows reception of your netwoirk by displaying its name. then connect. You will be asked for the password you chose. Done.

Yes you can so long as its an ethernet cable.

http://www.dlink.com/products/?tab=3&pid=WBR-2310&rev=WBR-2310

Has the manual and helpcenter.

Jack,You'll find all you need to know here:

http://www.dlink.com/products/?pid=WBR-2310


JOAT

So that means you are able to connect to the network with the ethernet cable only.
Did yopu try to connect to the wireless network ?
And if yes then what was the error message ?
Click Here for more info about wireless connection. Pl. go through the web site you will get the answer !

Go to this link:
http://www.dlink.com/products/?pid=470


Proceed to download required software.
Remember to give a good rating for a good comment! Thank you for using fixya.

you have to change your channelk type in your wi fi router.
For that access your router with following link

http://192.168.1.1 or
http://192.168.0.1

if you have belkin router
http://192.168.2.1

type user name as "admin" and password is "admin" or blank or "password"

then go to wi fi ->advanced setup chang channel type 4 ,6 ,11
change chanel type 1 by 1 and check signal strength.
everyt time save settings and restart both computer and router after save settings.

Thanks for using fixya.
Please rate this solution if it helps.

check wther your wireless in on and even check that on router mac filtering is on,problm mite b your laptop is not getting detected by your router,jus check wther both are on,

Sounds like a defective modem/modem failure if, it does not reset or if you take all of the other wires out and just leave the power in and none of the other lights go off then that is definitely a defective mode, I suggest either returning the modem to where you purchased it from or calling D link it should be covered under there warranty for replacement.