I need a wiring diagram to connect up my kenwood amp, cd player, tuner and graphic equaliser

It would be normal practice to connect the Equaliser via the tape in and out of the amp, to the Equaliser in and out. If you are using a tape deck, then that goes into the Equaliser's sockets for tape decks.
I wouldn't use the Equaliser on any of the Dolby or other coded sound modes as it could effect the signal.

Here is as close as I can get, they don't have the exact manual but maybe you can find something close
https://www.hifiengine.com/manual_library/kenwood.shtml?category=graphic-equaliser

Connect your Denon outputs to the Realistic main inputs.
Connect your Realistic main out to the Rotel tuner in.

Connect your Technics out puts to the Realistic Tape 1 inputs.
Connect your tape 1 out puts to your Rotel cd inputs.

And you should be good to go.

First of all connect the source, the tape or the DVD, to the input of the equaliser, use the output to connect to the AUX of the amplifier. make sure that the L&R are not crossed over. In case your amp has an in and out of the preamp section use then connect the source to the amplifiers input specified for the source like tape or DVD or TV and use the preamp output to the equaliser input and the output of the equaliser to the input of the main ampflier. Now the bass and treble of your amp can be set to the mid point - 12 noon position and use the boost or attenuation according to your choice of music. hope you find my advice helpful. Good day

If your car has a factory amplifier, you probably tied the kenwood's antenna turn on lead (blue) with the factory amp turn on wire. That bue wire only supplies voltage when your source is tuner. you need to use the kenwood' amp turn on (blue/white) to get the factory amp to turn on with the cd player and the tuner

MAKE SURE U HAVE ALL OF THE COLORS MATCHED UP ON THE WIRES

Thanks guys, but i solved my problem, i experimented and decided that i would run my DVD player (Aux Out) as a CD player through the Equaliser in [Rec] and from equaliser out [Play] i went into Tape Play on Amp, then i connected my Turntable CD Radio System to the Tape 1 Rec on Equaliser and then from Tape 1 Play on Equaliser went into the Tape 2 on AMP then i could use Aux in on Amp to connect my Laptop via my laptops headphone socket my laptop has an equaliser so i didn't need to connect to pioneer EQ, i also connected a small 5.1 to the DVD's 5.1 and connected 4 *45w Speakers to the AMP. and i can say it was FANTASTIC i couldn't get to 5 on my volume it was un @$#%believable.
My Quote
"Where there's an In, there's an Out".

Wiring diagram for a-45 stack system

connect your media source(dvd-cd player)to equalizer in-connect equalizer out to amplifier line in-or aux in-connect amplifier out to your loudspeaker.

The power amp does need an imput signal ie. tuner, cd , and such to play. You can use the power amp with the other equipment.
Good Luck
BIG RED