Question about Maytag Legacy Series Top Load Washer

1 Answer

NOISY DURING SPIN CYCLE

MAYTAG TOP LOADER IS VERY NOISY DURING SPIN CYCLE.
DOESN'T MOVE OR **** AROUND SO ITS BALANCED O.K.
SOUNDS LIKE HELICOPTER READY TO TAKE OFF.

Posted by on

  • Anonymous Mar 16, 2014

    Noisy during spinning

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 124 Answers

If this sound starts slow and gets faster till its helicopter sounding you probly have a verry worn spot on the drive belt when that spot goes around the pully it will thump the faster ti spins the more frequent the sound If you tilt the washer back you should be able to see the belt to examine it if this the problem
replace the belt
Hope this helps
please leave feedback

Posted on Nov 27, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Very noisy when on spin. The machine seem to be balanced however the noise on spn is like a jet taking off. it gets louder as the spinning speed increases.


Most noises from a washing machine occur during the spin cycle. If you hear loud thumping during the spin, the load of clothes may have become unbalanced. Stop the washer and redistribute the clothes, then re-start it. Repeat these steps if necessary.

Mar 28, 2010 | Maytag Washing Machines

1 Answer

Top loader Maytag washer cannot balance load


The shock absorbers that hold the tank are broken. Then the load will move the washer all over the place.
Look online for an exploded diagram and order the new shocks for it

Nov 12, 2009 | Dryers

1 Answer

Make loud noise during spin cycle


Washer may be out of balance, Move closes around in washer and restart

Oct 24, 2009 | Maytag Atlantis MAV6000 Top Load Washer

1 Answer

Noisy Spin Cycle


frigidaire frontloader infamous for rear bearings going bad,NOISY is probable an understatement. I wold open door and grab hold of inner tub, try to lift it up a bit, problably a bit of play in there, thats an indication of bearing failure, call authorized servicer possible warr parts

Feb 22, 2008 | Frigidaire FWT449

1 Answer

Thumping and banging


make sure all shipping pins are out the tub should move all around from side to side if it level still bangs its eather the balance ring top basket are there 3 slides on a plate above the motor just put some silacone oil on tham move around

Feb 09, 2008 | Kenmore 24032\24036 Top Load Washer

1 Answer

Danby washing machine noisy only during spin cycle


hi there,

Most noises from a washing machine occur during the spin cycle. If you hear loud thumping/or sound
during the spin, the load of clothes may have become unbalanced. Stop the washer and
redistribute the clothes, then re-start it. Repeat these steps if necessary.

Jan 13, 2008 | Danby DWM99W Top Load Washer

1 Answer

Whirlpool LHW0050PQ Front Loading Washer VERY NOISY during spin cycle


remove the top access panel 3 screws in top rear.
now look around and push on the drum from top
it has suspension shocks and springs like your car they should resist any movements.
look/wiggle the concrete balance blocks , no cracks or loose.
inside the tub are the arm solid /not loose.
run it with the top open what do you see/hear and where
look under the rubber flap in front did anything get under the tub

Dec 29, 2007 | Whirlpool LHW0050PQ Front Load Washer

1 Answer

My old Hoover top loader Washer is noisy & doesn't spin out properly - how can I fix it?


Sounds like the switch which cuts the machine off when the load is unbalanced. My guess is that: This switch is being triggered too easily The springs holding the bowl up are either stretched or one is broken; The machine may not be level.

Mar 30, 2007 | Hoover HTC243 Top Load Washer

Not finding what you are looking for?
Washing Machines Logo

476 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

jimorris77

Level 3 Expert

411 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

Bill Long

Level 3 Expert

606 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...