The electronic spark continues after the burner is lit. It continues even if the burner is turned off. this continues for about a minute before it stops

I have had this same issue with continuous sparking after a burner was lit.
Problem 1. Wet or dirty ignitors/burners. Solution: clean and/or dry (I assume this resolves electrical issues). This has usually solved the problem
Problem 2. Stuck or dirty control switch. Solution: remove knobs and spray electrical-cleaner into switches. AMAZING... no more clicking plus burners now burn hotter when set to HI. I assume this frees-up the movement of the switch to prevent it thinking you are pushing it ON... and thus asking for spark... plus greater range of switch and/or higher flame settings available once lit. A no-cost miracle! ( I used "PureTronics" brand Electrical Contact Cleaner spray can, 1 sec, 2X).
Mike S

Hi,
Here is a tip that I wrote that will help figure out why the burner spark keepson clicking...

Gas Range Repair Burners Keep on Clicking
heatman101

I found a satisfactory answer elsewhere on the Web. Thanks.

OK, the best action is to call for service, if the unit was just installed, and purchased. This unit should be covered at this time, by the manufactures warranty, or store 30 day warranty. This repair should be free. The culprit will be a faulty spark ignition switch, and module. Testing is required. Once this switch, or(module), is replaced, the unit will operate correctly.

I have the same problem all but one burner. When using the other burners the igniters keep sparking after being lit. What do I replace?

Hi,
Here is a tip that I wrote that will help figure out why the burner spark keepson clicking...

Gas Range RepairBurners Keep on Clicking
heatman101
fsggfs

sounds like you have a bad switch. maybe on the large burner.. some of those switches can be replaced without the whole harness.

Turn the knob back towards off about 1/8 of a turn and you will take it off lite and it should fix it.

I have a Creda gas stove ,yesterday some water boiled over. I have a continuous spark ever since and the stove is not even on. Is there any way to reslove this without calling a repair person?

Our GE cook-top burner igniter has started ticking even when the oven is shut off. Even after cleaning the bottom of controls the ticking persists. Any suggestions? Thanks