I was given a Weslo cadence 825 treadmill. I need

On the rear of walking deck you have the left and right feet. Down the deck is at 0 degree incline, fold them up and you have a 3 degree incline.. You have no incline motor on this model.

Your best bet is to read pg 18 and 19 of the user manual
where it will show you where the release latch is and how to disengage it properly.

Remember to have unplugged the unit while you are doing this

download a copy at
https://www.iconservice.com/CustomerService/manualsProductManuals.do?model=WLTL27308&modelName=WESLO+CADENCE+CT+5.8+TREADMILL&version=1&company=11&language=

ICON Health Fitness Inc Customer Service User Manuals

RUN the software calibration for diagnose, troubleshooting , fix it.
adjust the speed sensor, clean it and tight the wires connector
LUBE the deck belt+rollers bearing too
SEE THE diagram.

God bless you

LOOKING FOR THE USER MANUAL FOR THE Weslo CADENCE 200CS Treadmill

FitnessRepairParts may be able to sell you a manual if you can't find it anywhere, depending on which version of the 825 you have (there are quite a few.. check for other model numbers on your machine
http://www.fitnessrepairparts.com/part_search/EquipmentSearch/weslo%20cadence%20825

You can also try IconService.com and click on "Manuals" - sometimes they have manuals you can download or purchase.

No the point of the safety key is to NOT work without a key.

Go to iconfitness.com click on customer service then diagrams input manufacturer then the brand name. This should give you the info you need to order your motor if not callthem 1-800-999-3756.

The only lube required is between the walking belt and the deck. You can get the lube from iconfitness.com. Lift the walking belt and squirt some on the deck from each side, underneath the belt in the area where you usually walk. Walk on it for a few minutes to spread the lube around.

I centered the belt on my tredmill and now it wont move at all. I tighted and loosened the belt. motor runs belt wont move

Hi, I don't have a manual on your particular treadmill but most all treadmills use the same type of belt tension and tracking, which is an allen screw adjustment on the rear tension bar. One on either side. You should have been provided an allen wrench with your treadmill, if not then use one of your own the proper size. Make the adjustment with the unit running at its slowest speed. Clockwise tightens the tension and will draw the belt. Good Luck, this should Fixya!