I have a Minnkota Riptide 80# thrust trollmotor.I have power to the head but motor will not run. It is a bow mount with twist grip control.When I mash on the power indicator button ,it lights up showing I have power. When I twist the handle to turn on motor, it won't turn on.

Hi I have a minnkota I pilot. I use with a remote control. For some reason there is power going to it but won't anchor lock or turn left or right. What could be the problem

check make sure its not wired backwards to batteries

The prop slides off with a shear pin behind it. Regards Phil

what handle, there is no handle.

max is 56amps on 24v system

These guy will take care of you,

http://www.jonestrollingmotor.com/

possibly a bad bearing or stripped gear.

I have minnkota riptide i had to take the handle off and a little spring & white plastic piece poped out of the handle i just wanted to see where it goes

Parts can be purchased from this dealer...There are schematics on the site for review....
http://www.northlandmarine.com/MinnKotaQuickRef.htm

Did the unit come with a strap to mount the transducer to a bow mount electric? Most units do... If not there is probably one available for the unit as an aftermarket accessory or accessory from the manufacturer... Regarding the transducer wire, just wrap and rout this up the front of the bow mount motor shaft so when you pull the motor up and secure it, it is not going to get in the way. You could cable tie the cord down near the bottom of the shaft and one up near the top where they wont interfere with the motor bracket when the motor is positioned up on the boat.