I have set my jvc stereo to the am and fm programs i want. Unfortunately the am stations comes out loud and clear on the stations because it has a highlighted tuned - lit button.. but the fm stereo light does not light up when on fm and therefore the sound is not as loud or powerful as the am?? How do I set the fm light to come on " tuned" or "stereo" ?
FM stereo will need a good aerial to work properly, but AM doesn't. If you have not got a good aerial, stereo will stay off. Though you might still here the station. It needs a lot of signal to make the stereo light activate. If was to come on in the weak state the sound would be full of interference. So the set keeps it switched off.
SOURCE: How to set a station with the remote control
1 Tune in the station you want to preset..(use >> >>
SOURCE: no fm reception
We had trouble switching from AM to FM. We finally solved the problem by pushing the reset button on the back of the unit (any sharp pointed object can be used to engage the reset button). Do this followed by setting the mode to FM and try tuning in your FM stations. Try the procedure several times and it may finally kick in, as was the case with us getting our AM stations
SOURCE: Denon UD-M30 Tuner problem I can
If the RDS data is displayed it mean that the discriminator circuit - the circuit that extracts the sound form an FM signal - is faulty. The circuit will have to be replaced, a job for someone with electronics experience: he must identify the exact model and version of the chip, replace it and adjust the phase shift if necessary.
SOURCE: How do I preset individual radio station frequencies?
To set individual presets:
1. tune to the station you want as a preset
2. hold down the number (ie "1") on the remote until the number blinks on the system
3. repeat for all other stations
press the number on the remote to tune to your preset
this is very similar to setting the presets on my car radio
2,069 views
Usually answered in minutes!
×