I suspect what you are describing is a convergence problem---when it acts up go into the customer menu and select convergence--then advanced--it will bring up a grid of lines---if red, or blue is skewed this is your problem.
I have repaired hundreds of these sets--this model uses two of the STK-392-570 convergence chips and I have seen many where the convergence comes and goes--what happens in these sets is not a soldering problem but the pins inside the chips come loose--Each chip has about 16 pins--I have had ones that when I removed the solder pins fell out of the chip.
The pair of chips can be bought on Ebay for about 12 dollars plus shipping (I know the best seller there) and if you or someone you know can do it you can save the set and a lot of money.
Most shops are going to charge at LEAST 300 for this repair--and some will not do it in your home--it can be easily done in the home and takes about 1 hour.
I HAVE START TO FINISH, STEP BY STEP INSTRUCTIONS FOR THIS REPAIR IN THIS MODEL.
If you think you can do it yourself let me know and we will get the instructions to you.
If you have any questions or need help--let me know by replying to this solution. I am here to help people.
If this information has helped you, rate this solution as I do this for FREE.
Thanks for using FIXYA!
SD TECH
Your tv has three piture tub guns in there. Your convergence board that controlls them to be in align is acting up.
175 views
Usually answered in minutes!
×