My kenmore dw just started having the green led that reads clean just start blinking.now it wont run thru any cycles except the cancel/ drain cycle.any suggestions? model 665.165352300
Hello, With the information you supplied I'm going to assume the light is blinking 7 times and pausing then blinking 7 times and so on.
With the door cracked open hit the following button combination:
-high temp wash
-heated dry
-high temp wash
-heated dry
Then close the door and hit cancel. The pump will run for a few moments and then you should be all set. Hope this helps Mike
START/RESET status indicator light flashing
You have pressed the indicator light flashing START/RESET pad while the START/RESET dishwasher is running. This will cancel the cycle. The light will stop flashing after the dishwasher drains (about 90 seconds).
• Press the pad once to start the dishwasher. Press the pad a second time when the dishwasher is running only if you wish to cancel the cycle.
Power to the dishwasher was turned off while a cycle was running and power has just been restored to the dishwasher. The blinking lights indicate that the dishwasher is draining the potential water inside.
• The light will stop flashing after the dishwasher drains. A new cycle will start automatically.
Good luck
89 views
Usually answered in minutes!
×