Indesit WIDL1265 flashing lock, rinse and timer lights. won't drain or spin

Flashing Lights
if the wash, rinse, and spin function lights are all flashing at the same time this indicates a potential obstruction in the drain or waste pipe. Worn carbon brushes can also cause this to happen.
https://mixrepairs.co.uk/all-lights-flashing-on-indesit-washing-machine/

Check the motor brushes and belt.

There is a Light Flashing on my Indesit Washing Machine

Many of our newer Indesit Washing Machines have a series of indicator lights, which flash to indicate a possible fault on your installation or simply to let you know a problem occurred whilst you were away from your Indesit Washing Machine.

Pre wash light flashing
Indicates a failure of your Indesit Washing Machine to fill correctly. Check your fill hoses for a blockage, a leak, a kink or to make sure that they are turned on.

Wash light flashing
Indicates that your programme dial has been moved from its original position. Simply returning the wash dial to its original position will restore the light to its original status.

Spin light flashing
Indicates that the Indesit Washing Machine has considered the wash load to be excessively un-balanced. Open up the door of the Indesit Washing Machine, re-distribute the garments and retry the spin to resolve this.

End light flashing
Indicates that the Indesit Washing Machine has reached the end of a wash programme.

Wash, rinse and spin lights all lit at the same time would indicate a possible blockage in your under sink wastes system. Check out the additional informationin our 'My Indesit Washing Machine Will Not Empty'

hi something similar has started happening to our washer, after the initial wash starts the machine doesn't do anything for a while then the red door light flashes on and off very quickly as does the 1st and 3rd green wash cycle light?

If spin speed happening during what should be Wash speed then sounds like faulty speed control module/ could also be Tacho has fallen off end of motor;small round coil operated by a magnet which pulses a speed control circuit in the module/check also pump is okay and filter clean.Try resetting if you can,book will show you how to..Good luck

Hello, this is a symptom of drum bearing wear, and what you need do is to check the wear to see if the inner drum moves up and down relative to the fixed outer drum. It should only moves a minutes amount. If it moves more than a millimeter or two, that means it is probably worn bearings and you will need to replace it.
Thanks

If the machin isnt able to evac the water, it wont spin. It will indicate error with 2 flashing lights + lock led. Check pump, drain hose.

my indesit washer/dryer wd12x programme dial goes all the way when it reaches spinning

washing machine working until final drain, rinse and spin then 3 lights flashing, door lock, stain removal and extra spin.

Unable to empty machine or unlock door.

any suggestions

sounds like your power board is damaged. Did you get any washes out of it before it went wrong