Enviracare ifd hepa 6001 filter question

something is loose maybe you put one in a little crooked and that is whey it would rattle or the screw that holds them in is loose , good luck

get a manual.....http://www.filtersolution.com/s.nl/it.I/id.4/.f#.W9Bgst-YWV4

HEPA is a type of air purifier. It stands for high-efficiency particulate air. To qualify as a HEPA filter by government standards the filter must remove 99.7% of all particles larger than 0.3 micrometers from the air. The following site lists the top 10 HEPA purifiers available online - http://www.air-purifiers-america.com/AP101_top10.asp.

http://www.honeywellpurifiers.com/ssi/pdf/honeywell/50100-200-300-manual.pdf

The Intelli-Check™ Filter Monitors will indicate replacement of the pre-filter and the

HEPA filter. Depending upon your individual usage (environment and hours used),

you may need to check and replace the filters more or less frequently.

To check Expected Filter Life Usage

When the unit is turned on, quickly press the appropriate filter monitor button. The

pre-filter light will flash up to 3 times and the HEPA filter light will flash up to 4 times,

depending upon how much expected filter life has been used.

PREFILTER:

1 flash = from new, up to 1/3 expected life used up

2 flashes = between 1/3 and 2/3 expected life used up

3 flashes = between 2/3 and all of expected life used up

Remains on = time to check/replace pre-filter

HEPA FILTER:

1 flash = from new, up to 1/4 expected life used up

2 flashes = between 1/4 and 1/2 expected life used up

3 flashes = between 1/2 and 3/4 expected life used up

4 flashes = between 3/4 and all of expected life used up

Remains on = time to check/replace HEPA filter

To RESET Filter Monitor

When the filter monitor light remains on, it is time to check/replace the filter and reset

the filter monitor, if needed. With the unit powered on, press and hold the appropriate

filter monitor button down for approximately 5 seconds until the light turns off.
Depending upon your individual usage (environment and hours
Page 6:

their may be a reset button on the cord where it plugs into the outlet .check this ..let me know ..good luck/joe

when the filter is full, pressing the button resets the cutout. either shake out the filter or replace with a new one.

IF RESET DOES NOT WORK DON'T WORRY
AS LONG AS YOU REMEMBER TO CHANGE
THE FILTER. CHARCOAL WHEN DIRTY AND
HEPA ONCE A YEAR OR SO.

When the filter monitor light remains on, it is time to check/clean the IFD™ filters and reset the filter
monitor, if needed. With the unit powered on, insert the tip of a ball-point pen or paperclip next to the LED
filter check light and hold for approximately 5 seconds until the light turns off (Fig. 3). Depending upon
your individual usage (environment and hours used), you may need to check and clean the filters more or
less frequently. If the IFD™ filters are cleaned before the filter monitor light turns on, the filter monitor
should be reset at the same time.

Where can I go in my town to get filters? I live in Vacaville,CA

The carbon filter should have the air passing through it first, before the hepa filter. The carbon filter removes the large particles which would otherwise block the hepa filter very quickly. Contact these guys if you need more help; http://www.bionaire.com/contactUs.aspx Hope this helps :)