Proform 490C showing error code ssytem cehck

Check the route of the drain pipe and check for blockages.

Google search showed this free manual page.

https://www.manualslib.com/manual/925783/Lexmark-X945e-Mfp-7510-Series.html?page=146

925.00
Service PC
cartridge

Description/Action
Outputs of the sensor (Y ATC) are not in the
specified range.
This error must be reset inside diagnostic mode
before troubleshooting or machine operation can
occur.

Go to
"925.00 Sensor (Y ATC) error" on
page
2-181.

-----------------------------------------------
Google search result:


https://printcopy.info/?l=en&mod=erc&brand=Lexmark&model=C935&code=925.00

Code

925.00

Description

Service PC cartridge Sensor (Y ATC)

Remedy

1 Reset the Y ATC failure lock out condition. 1. Enter diagnostic mode 2. Select Dev unit reset. 2. Select Y channel Perform a very large print test. Does the error continue? Go to step 2. Problem solved. 2 Check the sensor (Y ATC) for proper connection. Is the above component properly connected? Replace the Y developer unit assembly. Go to "Developer unit assembly removal". Replace the connection. 3 Perform a very large print test. Does the error continue? Replace the upper printer engine card assembly. Go to "Upper printer engine card assembly removal". Problem solved.

console is bad and needs replaced

To use the music port for iPod, you need an iFit Universal iPod Connector To purchase an iFit Universal iPod Connector call 1-800-533-1333

Ff dl (failure fault door lock)

Door Lock Error
A Door Lock Error occurs if the door cannot be locked. It will try to lock it 6 times
before displaying the error.
Potential Causes
• Door Lock Mechanism broken or removed from the Door
• Check Door Lock/Switch Assembly
• Check the wire harness connections to the Door Lock/Switch Assembly and
Central Control Unit (CCU)
• Door Lock/Switch Assembly Failure

The door lock may have to be removed and replaced to get past this failure.

I had the same issue with two new dryers. The rep on the phone said nP can also indicate a power issue. It turned out one of the wires in the outlet had broken off. Rewiring the outlet solved the problem.

i dont mean to be rude , but if its brand new call the company that built it and they should be able to help you. should be able to troubleshoot over the phone

HI,. this is a lens assembly fault. the lens is malfunctioning or, it may have stopped reading. this wrong disc code is just a universal warning that is concerning a fault if the main board doesn't receive any data(audio,video) when the disc is inserted.

Due to the integrated status of your unit, this will be a costly repair because, the entire assembly is combined together with the vcr section as well.

You will need to replace the entire assembly to fix this issue. the lens has burned out.

you can confirm my diagnosis by preforming a cleaning of the lens with a cleaning disc. if the unit continues to not read or play a CD after the cleaning, this will confirm my diagnosis.

Please rate and have a great day:)

I have same problem.Please let me know if u find an anser