Running a DAP 1353 in Repeater mode. The issue is a lack of signal strength increase.
Between my wireless modem DIR 615 and the DAP 1353 are 2 x single brick walls.
Between the DAP 1353 and the client PC is 1 single brick wall.
Signal strength on the client PC for BOTH is the same and about ~20%. Would have expect a major increase in signal
SOURCE: Routers
You cannot increase your bandwidth, if that is your question.. but you can increase the signal strength and/or your radius of access (distance from the Access Point) by adding what we call 'Extenders'.
Bandwidth is determined by the type of Wireless Specs you are running.. G is the fastest 'certified' bandwidth at this time. although the new "N' will be available soon.. (it is in stores now, but not considered a 'standard' yet... The release date is not due until 2009..
Here is a good guide to the various speeds:
http://en.wikipedia.org/wiki/IEEE_802.11
SOURCE: Network router printing issue
sure..you can put all the computers on the same workgroup, and form a network
we got fresh wireless drivers here too
SOURCE: Can't get to internet anymore
Try to remove the preferred networks on your Presario then try connecting again. If you have wireless security enabled on your router, you have to enter that. Make sure that the settings on your router is the same as your wireless adapter so that they can synchronize.
If you have difficulty with that, just ask me and I'll answer as soon as I can.
SOURCE: D Link DIR 615 and Acer notbook not talking
Run the windows wizard to setup a network connection from the control panel. Be sure you have the security type and code if you have security enabled on the wireless router.
BXH_5
SOURCE: signal loss
You may be far from the modem. Try getting closer. Or it can be of interference. Is there a wireless phone in your area? try removing that.
382 views
Usually answered in minutes!
×