Our GE Select Washer 7 cycle extra heavy duty capacity is overflowing no matter what water level it's on.

hi there.
this is all the info i can find on this.
Key Features

• Catalyst Cleaning Action with Direct Inject

• ENERGY STAR Qualified

• AccuWash Temperature Control

• Variable End-of-Cycle Signal

• 3-Tray Dispenser - Detergent, Bleach and Fabric Softener

• Quiet Wash Plus Sound Reduction System

• Ultra Capacity Plus - Stainless Steel Wash Basket

• 3.8 cu. ft. Capacity

• Multiple Cycles including Whitest Whites, Heavy Duty, Hand Washables and Add-a-Garment

• Multiple Wash/Spin Speed Combinations including High 1000 RPM Speed

• Delay Start

• 3 Temperature Settings

• Automatic Adjustable Water Levels

• Extra Rinse and Rinse/Hold Options

• Side-Swing Door

• SpillGuard Top

• Optional Stack Kit - 8541503
• or see if this link will help you out some more.

What is the capacity of front loading whirlpool washer MO GHW9150PWO...

Amazon.com: Customer Reviews: Speed Queen 3.3 Cu. Ft ...

www.amazon.com/Speed-Queen...Washer/.../B004ZO...

Amazon.com, Inc.Find helpful customer reviews and review ratings for Speed Queen 3.3 Cu. ... If you need more water in the tub you can hold down the reset switch until the machine ... I tried the delicate wash and spin cycle, but the clothes retain too much water and ..... It takes time to correlate the number of turns and the direction to turn it.Missing: overspeed

Commercial Washer and Dryer Problems

www.affordablelaundry.com/commercial-washer-and-dryer-problems

The water should shut off once it reaches wash level, if it doesn't, and water level hasn't... (these are the glass type fuses) be sure to turn power off before checking them. ... If you have the voltage in, but not out, it's the contactor. .... We repair: Speed Queenwasher, IPSO washer, Milnor washer, UniMac washing machines.Missing: overspeed

[PDF]View document in PDF

The solenoid that opens to admit hot water is either defective or not being energized by control panel.

Could be the water level switch is bad it cuts off the water when it gets to the correct level. Also could be the hose connected to it has came loose on either end . Could be the water valve is stuck open and can't shut off the water. Hope this helps.

The problem is the pressure switch has failed or the hose is plugged up, has a hole in it. These are usually inexpensive and are very easy to replace. Here is a video this will walk you thru testing and replacing a pressure switch. You can also enter your model # for diagrams and illustrations of your specific model. All parts come with installation instructions. Not all models are available.

Dryers not getting hot at all.

you have a broken coupler...this is a plastic and rubber part that connects the motor to the transmission.  A $20 part

How good are you and your tools?

Probably the drain pump seal has gone bad.
Check it for leaks.
If your floor is good and level look for water near the front center of the machine.

bad transmission,,check voltage...below 110 with load and water pressure switch or hose defective..

heres hteaprt numbr for both the water level switch and the connecting tube, before i replace he switch make sure the tube is connected to rear of tub nad isnot cracked or kinked, and connected correctly to the switch for that matter. a hole in the tube would hamper he switches ability to sense when unit is full

3356466 water level switch,3347780 pressure switch tube