How do i clean carona wire

It just Need Cleaning (or change) of Primary Carona Wire

carona wire check karo.transfer carona me leakage check kijiye.
DP unit ka bias patti barabar piche connect hota hai ya nahi check kijiye.

this is a drum unit problem clean carona wire grid wire and fix the unit properly.

e061 code is for fault in drum unit.change carona wire,clean carona grid.check wheather drum unit is fixed properly.

clean both corona wires or replace it(tranfer and charge carona)

check the main charge carona wire and the transfer and separation carona wires if all the carona wires are intact then the hvt board could be faulty

I know alot about konica minolta copiers and i would probably start by checking the drum and developer units. If it has carona wires, try cleaning them. Try cleaning the inside of the unit, be careful around sensors. If that helps with the copies then you probably just have a lot cleaning to do. Its most likley time for a pm. How many copies are on it?

check primary carona, sepration carona wires

Problem wit the black developer unit.

There is a sensor to clean inside the machine otherwise the dev will need changing

The Carona wire is cut. ther are two carona wires one is Main charger carona wire and another one is transfer carona wire.
Transfer carona wire is at the botton of the copier when you lift the top cover
main charger carona is in the top. it is in the drum unit.

then other may be the developer is not there (insufficient).
toner and developer mixer may be less.
for further mail me at [email protected]