Washed a medium load ok then shut down.

if you go to this site with the model# there is a repair help section, and a 877# help line.

www.appliancepartspros.com.

To gain access to the washer components, the front panel between washer and dryer must be removed first.
Remove the two top screws securing thethis panel to the unit.Tilt the transition panel down and pull itstraight out.Remove the two screws located behind the washer top.Pull the washer top forward to disengage the top locks. Disconnect the washer lid switch harness. Lift the washer top off the unit.Remove the two screws from inside the top of the washer front panel.Lift up on the front panel to release the catches near the bottom of the panel andremove the front panel.

it is your mixer value not shutting off.

If it is new, don't bother messing with it, Call for warranty service.

i have a frigidare washer dryer combo model fex831fs approximately 6 mo old . turned on a load and water gushing out from underneath, checked hot and cold hoses not leaking, water coming from underneath

You should bne OK to lay it down on its side - either one. Just make sure you line the pickup with some blankets etc so that you dont ruin the paint on the journey.

if it smell like wd 40..your transmission is defective,,need help replacing post question,,

Hi..I had the same problem yesterday...the maching would start when I pushed the button and then stop..I had to push the button again to get it going..My stacked set is around 8 years old.

Here's what we did..moved the washer away from the water source and unscrewed the water intake lines..there is a little screen there...took the screen out of both hot and cold lines..one screen has some debris in it..the other was almost completely blocked..we are on a well and sometimes dirt..etc..gets in the lines..

Today no problems doing the laundry..its working like new..

first check for any sharp edges, look inside around back and front of drum the felt seals could be bad.

Jirina, first check to make sure that both the hot and cold water valves are turned on. If that's ok, check to make sure the lid switch is being actuated. Check those first...Catriver.