Can come out when i remove glsses or take off jumper or hat

what will happen if you remove jumper?
have you looked at 4 wire thermostats at home depot? google 4 wire thermostat for more info.

• Red wire: Power (24V input in most cases).
• Green wire: Fan.
• White wire: Heating.
• Blue wire: Cooling.
• Rh: Heating power.
• Rc: Cooling power.

https://learnmetrics.com/thermostat-wiring/

Utube

test the rectifier

#1 says he has a blue hat.

If #3 sees two red hats then he knows he has a blue hat. Since he says he does not know the color of his hat, #1 and #2 do not both have red hats. They may both have blue hats, or one a blue hat and the other a red hat.

If #2 sees a red hat then he knows his hat is blue since #3 did not see two red hats. Since he says he does not know the color of his hat, #1 must have a blue hat.

if the battery sits in front you will have to remove it.most imports now a days are like this.once the battery is removed you should have ample space to remove the bulb. just make sure that you use a clean rag to install the new one as you must not touch the glss part of the bulb with your fingers or oilly rags.befopre disconnecting the battery make sure you dont need a code to restart the car or use the radio.

replace the hat switch. hat = High Air temp. This switch is located on the end of the air end and usually has 1/2" flex conduit on it. Remove the conduit. It goes to a box located on the frame near and under the airend. Remove the cover from the box tug on the wires at the hat switch to see which two wires need to be disconnected.disconnect wires unscrew hat switch. Put a new oring on the new hat switch and install new hat switch. Hat switch is the only switch that will give high temp and lose control power. Let set a while and can reset unless probe is broken off.

It seems that the electric motor is bad or the regulator.

there should be a cmos reset jumper on the motherboard somewhere close to the bios chip. Given you didn't mention the actual model and brand of mobo i cannot be certain. Also you can remove the little watch battery for a few minutes and it too should reset the bios.

The only way to repair this would be to replace the panel. It is not cost effective to do so.

can you place a thin screwdriver down through the top of door, between the DOOR GLASS and OUTER door panel. If you can, try to raise glss electrically SLOWLY guiding it past the the binding edge. Door glass will need alignment to perrmantly repair