My screen has gone white? even in the view finder

hi,
did you check the picture through the view finder ? if it is clear, then there may be snag in the monitor, normally the connecting cable to the motherboard become break, if so should replace it.
if the picture is visible when you turn the monitor to either side, then you can confirm the fault of the cable.

dear
first tell me when u close the lcd pannel , then is the view finder working fine , if not then
view finder cable is broken . u cant fix it your self as u need to open the camcorder .you must not be having the proper tools for that.
and regarding the lcd part , if the display is fine for a while ..and then
while using it it goes fade , shows grey colour or lines in it . then its lcd problem ...ur lcd need to be replaced .

cheak ur lcd srip and there is a samll switch that chaing over switch cheak it

Look fo the switch that has two setting. one of them will say LCD and the other Migt EVF if you have a view through your view finder this is your problem.

call Fuji and tell them that you would like to send in your Finepix to see if the cheap/defective SCR chip was used in your model. If so, they will fix for free.

Cloudy images are usually a result of ccd gone bad. Try power reset, maybe it helps..

my motorola w385 verizon phone quite displaying has white screen , it will not call out . thanks bob borum [email protected]

Screen or main board failure. If it is still under warranty you may have a chance bit if over a year or so old - not worth considering for repair- though you could try. take a look through the file here http://www.fixya.com/support/p423-nikon_coolpix_5600_digital_camera/solutions

just buy a new TV, because its costly for repairing

If the view finder shows the same white display. You probably have display circuit problem in the camera. Faulty CCD chip usually shows Black screen so it probably board problem or a connector problem. If you see an image through view finder then you may have defective connection from board to LCD assy. Either way it need to be looked at by a trained technician. Good luck.