Replacement bezel for my Luminox 3003 watch?

Replacing the spring pin is not a problem, however for the band to look as it did originally, the end piece, or end tab - which is now missing, must be replaced. These parts are generally proprietary. You can order one from your local Certified Master Horologist.

You may also consider contacting Luminox. Sometimes, the manufacturers run out of these parts and the whole band must be ordered because that is all that is available.

Contact Luminox Repair Center at 401?946?0920.

mcdevito75 here, BEST BET for your Navy Seal watch, look for a small watch repair shop in your area for this part.

You'll need a watchmaker to fit the new bezel. If it is just scratched I wouldn't recommend fixing it. You may pay 50$ for the new bezel and a pressure check; that may not be economical.

If this is stuck and just wont turn that means its full of yuk and muck and just needs cleaned ou, take to a good jeweler who can clean under the bezel...if it turns but simply doesnt click that means that the click spring mechanism is broken and would have to be sent to Luminox for repair...good luck :)

Try parsecent.com, you can get a replacement bezel there...

and you are right, you are basically buying a new watch as this model is made of plastic and cannot be 'polished'. Refurbishing it means that it will look new and everything on the outside would have to be replaced...good luck :)

buy a new watch

Grab the knurled edge of the bezel and turn counter clockwise. It only moves in one direction- to the left, counter clockwise.

I was shopping for one in Thailand and it was a GE 371. I did not replace it because they only carried the cheap china battery's.

best bet is to contact luminox...i had to do it for mine. Even if it was a purchase from a third party, they may take care of it for free...

I have this same problem and sent it to Luminox and they fixed it for just the shipping.