How open wahser in OLD thin twin stacked dryer/washer

Could not find much, try links below.

TwinThin dryer element changed

Whirlpool LTE5243DQ 24 Thin Twin disassembly Google Search

https://www.google.ca/url?sa=t&rct=j&q=&esrc=s&source=web&cd=1&cad=rja&uact=8&ved=0ahUKEwiIkL7k4qrLAhUrmoMKHfDBCroQFggbMAA&url=http%3A%2F%2Fwww.whirlpool.com%2F-%5BLTE5243DQ%5D-1001396%2FLTE5243DQ%2F&usg=AFQjCNEsnkLT2Ac9T6mBdT3q0XplDgWH8w

Whirlpool LTE5243DQ Repair Manual Stack Washer Electric Dryer

I can not find your model number that you posted.
I can tell you that all whirpool thin twins up to last year were direct drive with no belt except for the dryer section. Whirlpool stackers from the early eighties did have a washer belt if yours is this old replace the entire machine.

the water inlet valve is worn out and will need to be replaced.


merry christmas

first access the tech sheet and run any diagnostics it shows for the machine and if this passes,then check/change the fill switch on the control panel along with fill tube from the wash tub base if kinked or plugged

HAS BAD WATER PUMP CALL REPAIRMAN

defective timer...a model # should be under the lid...or open dryer door and on front dryer panel right hand corner..onthejob

My twin stacking whirlpool washer/dry. The timer switch kicks on but does not dry clothes kicks off after 5 mins but, clothes still wet.

the thermostat might need replace

if that mark is comming from the dryer .the drum has a rust. and you cant paint it or the seal of the drum is bad that seal is around the drum.

Check for voltage at the water inlet valve with the timer dial pushed in or in an off position. If no voltage replace the water valve. If you do have voltage you'll have to trace the circuits back from the water valve to the line. One point of demarcation is the water level switch. Pull the violet colored wire and see if it still fills while off. If it does it's likely the timer's bad.