I just moved into a flat with the WMA641 w Beko Washing Machine. I loaded it and turned it on : settings : Delicates 30 degrees. Pushed the on button and nothing happens. after few seconds the on light starts to flash. Pushed it again and stops flashing for 3/4 seconds then starts flashing again. With other washing machines when you start it you can hear water rush in and the whole cycle starts. But now I hear no water going in. Checked that the water was on and connected to machine from the back and it seems ok.

There are two wash cycle programs that default to a 30 degree wash for the Logik L814WM16. Set the machine program to Delicate or Eco to get a 30 degree C wash. Note: the Eco program has a maximum load of 2 Kg. The maximum load for the Delicate program is 2.5 Kg but may be lower when washing some fabrics.

There are also programs for Cottons at 20 degrees C and Express 15 degrees C. See page 17 of the manual, available here: https://manuall.co.uk/logik-l814wm16-washing-machine/ .

I hope this helps.

Cindy Wells

Gorenje has some documentation for their washers here: http://www.gorenje.com/simplicity/en/washing_machines/simple_manual_for_washing . The numbers indicate the water temperature (in Celsius) for a given cycle. The common choices are a cottons load in hot water (60 degrees). This is great for towels and other whites. The mixed load is for permanent press that can be in warm water (40 degrees). Then there is a cold water cycle for delicates (30 degrees). However, you should check the fabric care label before choosing the cycle.

I hope this helps.

Cindy Wells

is it going to a rinse hold.awaiting instuction to finish wash?

I had a similar sort of problem, and finally called a Beko engineer out. The machine was pushed too far back and had either blocked the water pipe, or waste pipe.... can't remember which, but simply pulling the machine out by an inch cured the problem!

You need to get the dial to 90 degree program then push the start and on button together. Keep hold the start button then a light will flash. Then move the dial to spin/drain option and press start to start the reset test mode. Hope this helps.

Had the same problem this week. i bought the machine of a mate and was ready for kicking his head in, but thankfully before then i found that this method resets the washer, hope it works for you also
Turn power button off (not at wall)
Select 90 degree wash
Press Start / Cancel button down for 3 seconds and turn power button on whilst still holding buttons down - Start light will flash.
Leave power on.
Select any Spin position.
Press Start and Cancel button at same time again for 3 seconds - other buttons may start to flash - if they do, press Start /Cancel button again for 3 seconds.
Machine should be re-set ready for use

go into service mode and reset

to do this move to delicates turn on dryer and keep
pressed down cancel button for about ten seconds release
then all lights should flash when you press cancel again machine will go through test mode , then just turn machine off
it is now reset, this worked for min a drcs68w

Sounds like you need a new timer.  Sorry.

Replace lid switch