We have had our washing machine for approximately 9 months and I have begun to notice that some loads do not spin at the full speed and when the machine finishes the clothes are still quite wet. The cycle completes and it goes through a long spin portion but it never gets up to full speed (800 to 1200 rpm depending on the cycle chosen). It begins spinning gradually faster and faster and then slows to near stop the speeds up again for a bit then slows down (I assumed this was part of the process to redistribute the load so that it would be in balance before going high speed). This process continues for several minutes and sometimes it takes off to full speed and sometimes the cycle finishes without ever getting to the programmed speed. Is this normal? Thanks in advance.
1,014 views
Usually answered in minutes!
same problem, but we also get an error 3 code. I've cleaned out the "trap" at the bottom front right of the washer, and this does not seem to fix.
we are in the country, so our drain to our septic is 6 feet or so above the washer, and in a different corner of the house, to install the drain, I installed clear tubing that goes up 8 feet, through a one way "trap" valve, and then into one of the main waste water lines on our basement ceiling...it worked fine for the first year, but is this the problem?
when the electricity goes off and on the washing will not spin .
I have the same problem with my wfmc640suc front load Bosch washer. Anyone else have this problem and what was done to fix it?
My clothes remained soaking wet and never got up to the full spin 800 rmp on my 100 model. Only one sweatshirt in load, so it can't be a balance problem right?
Bosch Nexxt 700 Washer will not reach full 1200 RPM spin speed.
×