Dayton 3E227A Heating Cycle

Dayton 3E134E Troubleshooting guide - manualzz.com

manualzz.com/doc/1285710/dayton-3e134e-troubleshooting-guide

This heater must be installed and serviced by trained gas installation and service ... Dayton High-Intensity Heaters ® Description Dayton high-intensity heaters ... ofinfrared radiation by heating a ceramic refractory material to incandescence. ..... 3E133, 3E461, 5VD63, 5VD64 90,000 BTU/H Do not mount heater horizontally.

[PDF]Fall Heating - Plumbing & HVAC

plumbingandhvac.ca/images/documents/PHVAC_Sept-Oct03.pdf

Nova Scotia gas utility eyes dealer network ... valve underbody and screw trim pieces ... Infrared requires a different way of ... gives you a crisp picture, and speeds up pipe locating. ... tiative will keep HVAC contractors busy ..... labelling for equipment usinghigh pressure R410A ..... Multi fired from 90,000 to 179,000 btu/h.

Dayton is a Graingers Brand. Go to the site below and I'm sure you can find your part. Put in your Part Number...Jim


http://www.grainger.com/Grainger/rp_parts_home.jsp

Go to grainger supply.com then go to dayton heaters with your model number and part number if you can find it,along with description of parts you need. I have been dealing with them for years and they are the main distributor for dayton furnaces.
They carry a large selection of parts and generally ship within two days. Hope this helps you. Thank you.

Check the high and low snap disk and check wall thermostat if fitted.

I think your best bet is to go to Grainger.com. and go to repair parts for dayton furnaces with your model and serial number and part no. if possible. You can also call1-800-323-0620 and get location of dealer nearest to you.
I have dealt with them for many years and they have always treated me right.Not always the cheapest but I have been happy with the service and the expertise of their staff. I hope this helps you and have a good new year.
Thank you.

I would check out the flame sensor it needs cleaning

Hi blow heater out with air line flame sensor could be dirty check out pressure switch jump this out see if it lights

Here in Vermont we design heating systems to perform at -10 to -20 degrees. Depending upon how tight the doors and windows are, it may if your temperatures don't drop below 20 degrees. It may take a while to heat up and I would not expect any temperature over 62 degrees inside the garage. Maybe a 50,000 Btu heater? Remember the output may be 20% less than the rated input of the heater.

Dayton heaters. com?
14 years old? dayton still exist?
Stop trying to blow self up--go buy new one