Paper pulls to right side and bunches up

Did you select photo paper in the printer setup before you tried to print?

Did you ask for support from the folks up at Canon? This appears t be a software issue.

Is it brand new? The print head rail may have a protective plastic piece covering it. Pull that out and it should work better.

The code "E2" on your Pixma MP190 indicates that the paper is loaded incorrectly.
After correcting the problem that caused the error, press the or button.

1. Remove paper from the rear tray.
   
   
2. Open the paper output tray and extension. (See and in Figure 1 below.)
   
   
3. Set the paper thickness lever according to the media being used. (See in Figure 1 below.)
   
   Note: For paper thickness lever settings, use the following setings for the media type being used: Right side: Envelopes / T-Shirt transfers. Left side: All other media types.
   
   * Figure 1
   
   
   
   
   
4. Divide the stack of paper into two or three piles.
   
   
5. Fan out the sheets of paper so that they do not stick together.
   
   
   
   
6. Load paper in the rear tray with the paper's print side facing up. (See in Figure 2 below.)
   
   
7. Align paper to the right edge of the rear tray. (See in Figure 2 below.)
   
   
8. Pinch and slide the paper guide to the paper's left side. (See in Figure 2 below.)
   
   * Figure 2
   
   
   
   
9. Press or button to clear the error.
   
   

Unplug the power cord and open the cover and remove all the cartridge and try to look I inside around the roller and try to manually roll the roller and if you can see the paper try to pull is slowly.

Have a nice day and do not forget to rate please...!

Canon support has info regarding this problem for your model. You must be willing to type in the question:
"Paper feeds skewed" and click <Search> button.
Review the top solutions. I recommend that you clean your feed rollers.

Canon MP190 Feeds Skewed

Use a flashlight and small mirror to look down where the paper goes in the back, usually something has fallen in where it shouldn't be. A lady last week turned her printer upside down and shook until a bic pen fell out.I find pins, paper clips, toys, or gum inside. That one roller us usually enough.

The unit does not power on.
(1) Check the power cord
connection.
(2) Check the connection between
the SPCNT board (JPSU1) and
power supply unit.
(3) Replace the power supply unit.
General
errors

Check the adjustments for the paper your using. Open the printer and look on the rollers you'll probably find paper or an obstruction clear it and also clean then rubber moving parts with isopropyl alcohol to give them their grip back.

gears below the paper feeding tray are damaged or some dust particle have blocked the gears try to clean it by blowing the dust use normal greece (oily substance) between the gears so that they can move frequently to pull the paper, and if the gears are damaged you have to change the gears.