Pantech c120, stuck on vibrate alert

I can imagine it how annoying it would be to you to see your cell vibrating instead of playing your favorite ring tone. Most probably it could be because of incorrect Profile configuration. It is possible to make your phone vibrate in almost every profile so we will assume that it is the reason for your problem too. Do the following and check some parameters as described.

1. Go to Menu > Settings > Profiles
2. Select Profile and then Select General.
3. After selecting General you will be given 3 options (Activate, Personalize, Timed)
4. Select Personalize.
5. In the Incoming Call Alert field, select Ringing.
6. In the Ringing Tone field, select your favorite ring tone.
7. Scroll down, (push down button) the next field would be Ringing Volume. For now select the max.
8. Scroll down to the Vibrating Alert field and set it to Off.
9. Scroll further down thill the very last field where it says Alert For, select All Calls for this field.
10. Save your modifications.
11. Activate the profile and see if it works now.

Only and only If it doesn't work, it may be due to software corruption.
In that case reset your phone to the factory default settings by going to:
Menu > Settings > Press UP button.
Select Restore Factory Sett. give your Security Code (default = 12345) and viola.
(Make backup of your messages ad contacts before attempting this)

to change the alert tone for pantech link: go to “menu”, go to “settings”, go to “profiles”, if you want it to ring and vibrate, choose “vibrate and ring” then go to “edit” which is the key at the very top left of the keypad, go down until you get to “message sound, go to “select”, “audio” and then choose the tone you want. hope that helps…i just figured it out today.

Menu/ Settings/ Profiles/ Highlight either "normal" or "vibrate and ring" then hit Options and go down to customize. *note only normal profile and vibrate and ring profile can be customized, the other three cannot.

Go to:
Menu>Settings>Profiles>Options>Customize and see if you can fix anything there.

you may have you phone set to a "silent" profile

you need to go into profiles and select a profile you like and then you can edit it (or create a new one)

In the menu, to to "Settings", then "Sounds & Alerts". Put the select bar over "Normal" (if that's the setting you use it on), pressing the "Options" button and selecting "Customize". Find "Keytone Type" and press the left or right arrow buttons to select "Off". Then select "Save". You can do the same for "Vibrate and Ring".

please help me unlock my pantech phone

change the speaker on the phones and also have the ringer check on the main-board.

Try pressing * , it works on the C150

press the * button and hold it down that should take it off vibrating mode