Hi,
when powered on, my printer starts rotating the toners. Immediately after the typical initial rotation, it does a second one, faster this time, and after that, the error light starts blinking slowly. Status monitor says to install cartridge with x color, x being any of the colored ones (usually a different toner each time).
i have removed and reinstalled all toners numerous times but problem persists.
Hei, yes you can buy new toners but usually this problem is caused by toner dust, you have to take out your toners, and clean the contact chips and reinstall your toner. also there is a mechanism whats reading the chips that can be dusty.
My Konica 2430DL does this every time I start the printer, I am quite sure it is supposed to do this as I it rotating the toner and calibrating itself. On one occasion I recently had the status monitor say to install cartridge... I removed it, shook it, reinstalled it with the same results. I just purchased a new Konica brand toner, replacing the old one and 'voila' sucess! It still does the little dance (rotation) every time, but it always has, but after installing the new toner the message went away. If you reinstalled the toners, this may be your problem - you need all new toners; spendy but it should solve your problem, otherwise; if you've already done this, I don't have an answer. Good Luck!
320 views
Usually answered in minutes!
×