I have a DWL-2100 AP. I cannot get it to reset to the factory defaults nor can I access the last know LAN IP settings. Is there a "secret code" of button push and disconnects that will really do a reset?
Thanks
Once reset right click on the connection in the task bar ( icon with two computers) click status, click properties, scroll down and select Internet Protocol (TCP/IP), click properties, click use the following IP address:, and add the following:
IP: 192.168.0.66
Subnet: 255.255.255.0
Default Gateway: 192.168.0.50
Click OK, OK, and Close, Now Enter 192.168.0.50 in internet explorer and it will work. You can now change all the settings you wish to.
Hope this Helps
Admin
CCNA, CCSP, MCSA
If you look at the back of your access point you should see a reset button. Hold that in for about 30 seconds and then log back into it. The IP address should be 192.168.0.50 I hope this solves your problem
I have reset the dlink 2100 ap, but now the IP shown on the bar (wireless connection) is 192.168.1.3 and is not possible to enter into the access point with the default IP and config it...any help?
Reset, hold for 10/15 secs, do it again 3 times total. Then it works.
28,782 views
Usually answered in minutes!
I tried this. I've held reset for 15 sec, 30 sec, 60sec. No dice. Logging to the IP of 192.168.0.50 just won't work. Any other ideas?
×