Maytag Epic Z with error codes F20 and F24

Make sure water supply is active, that hot and cold hoses aren’t reversed, and that screens in hoses and valve aren’t obstructed

https://www.youtube.com/watch?v=t3Gv9EI-upo


check that out............

cheers

F20 means that the unit isn't detecting water is entering the machine quick enough. When the error code appears if there is little to no water in the tub, then you have an issue with either the water supply to the washing machine or the electronic water valve. If the washing machine fills up about 1/2 way up the door and is overfilling with the water, it means that your pressure switch is faulty and will need to be replaced because it's not detecting that water is entering the machine.

Hi,

If your washing machine will not fill, only hot or cold will fill or is slow tofill then read these tips. I have covered many of the things that can happen inthese tips...


Washing Machine Problems No Water

Washing Machine Fix Washing Machine No Water

heatman101

The following list of codes indicates an electronics communication problem with the washer: * Epic® washer - F05, F07, F09, F10, F11, F13, F14, F15, F21, F22, and FdU
* Epic ZTM washer - F01, F11, F23, F24, F27, F28, F29, F30, F31, and F33


To remove the error display, press Pause/Off or Pause/Cancel twice.



If Pause/Off or Pause/Cancel does not work:

1. Unplug washer or disconnect power for one minute.
2. Plug in washer or reconnect power.
3. Re-select the cycle and press Start.

NOTE: If the error remains on the display, call for service.

Hope this helps.

F20 error code indicates no water detected entering the washer. Be sure the drain hose is not down too far into the drain stand pipe & both hot & cold water is turned on & working.

The "F24" error code is a heat sensor error code. The following link explains the error code in detail and the steps to correct it:

http://www.fixya.com/support/r1976126-f24_error_code_whirlpool_duet_kenmore

In many cases, the connector plug on the NTC sensor wiggles loose and causes the error code. Check the NTC connection first to make sure it is tight and making good contact. This may save you a service call and/or replacement parts. Make sure you UNPLUG the washer before servicing anything inside the unit.

A replacement NTC module (if required) can be purchased at searspartsdirect.com for about $10. The part number is 8181705. Refer to the parts illustrations under the "Tub and Basket Parts" heading for item 26 as a pictoral reference to assist you in locating the sensor on your washer.

If you have any questions, please let me know. I hope this helps you.

its water inlet problem (no water or insufficient water supply) check your washer inlets, maybe the water valves are off or you don't have enough water pressure.

i also have a magtag epic z &f 24 error code is on my washer. i don't know what to do.