At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
I have an old 357 model 19 smith and wesson which i lost the lever to release the bullet chambers? where can i get a diagram or spare parts list to help order the exact parts. [email protected]
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The PD series is Smith & Wesson's idea of a handgun that is lightweight enough to be always on hand when needed but it is not necessarily intended to be shot often. Carry ability and concealment are optimized while heft and shooting comfort are sacrificed.
"Personal Defense", PD as opposed to a gun that is mainly intended to be a range gun, showpiece or race gun (Performance Center, PC) or sidearm for military or police (M&P).
Smith & Wesson introduced the Model 686 in 1980. It is the stainless steel version of the 586, which was a blued steel finish. It was chambered for .357 Magnum and .38 S&W Special +P calibers. They are available ported and unported with a choice of 6 or 7 round cylinders.
The gun you our asking about should be around $1200.00. The smith and Wesson does not make that gun any more they where the first one to manufacture them. The serial number is pretty low 66 gun maid in the first run of the 357. So your number is in the right area for a good price in fact any Smith an Wesson 357 our worth a lot so good luck if your going to sell it. If you list it on gun for sale . com you will be bared with offers right now the prices our soring.
Hi! Kevin.....bit hard to know !....assuming ammo is correct dimensionally & of good power., & extractor & ejector are in order & chamber is good & slide is free & full sliding......then my first guess would be sticky firing pin not retracting properly thus stymying ejector action.......any stickier & you might get full auto ?......are you puncturing primers ?.. if gas back escape is part of the picture , bullet may not leave barrel . I suggest you do full strip , incl firing pin , clean & remove any burrs ..... worthwhile to run some dummies by hand & see how they behave..........jimbanjo
Lock the slide back (after unloading), turn the little lever on the left side straight up, release the slide back foreword, pull the trigger, and remove the slide forward. Good luck.
This is a dialog I had with a dealer: Ann: How can I help?
you: I was wondering where would one go for watch parts for the sw tritium watches? Ann: Smith & Wesson watches, Correct you: yes Ann: Here is the contact information for them Ann: SMITH & WESSON Ann: CAMPCO Ann: 4625 W. JEFFERSON Blvd. Ann: LOS ANGELES, CA 90016 Ann: www.smith-wesson.com Ann: 888.922.6726 you: thank you
ooof i know how to put i back together and can teach you but its a doozi over the net. hows your experiance with airsoft internals also wat type of gun is it (spring gas aeg etc shotgun assault rifle pistol etc. email me @ [email protected] i can help you further with that info
×