Replacement part for Asko Dryer T700

Well, if the vents are perfectly clean and unobstructed the only thing I can think of is that the thermal switch designed to turn off unit when overheating is opening prematurely.
Might have to be replaced.

Hi.

The loud banging noise in the spin part of the cycle is usually caused by bad drum bearings. The repair is carried replacing the bearing at the back of the drum. Such kind of replacement is carried disassembling most of the appliance to reach the back of the tub. If you have not done similar repairs before it may be better to call a technician ringing the Asko support number listed on the owners manual.

Regards.

Ginko

Sears lists 2 model Asko dryers The T700 and T701 Both use the same rollers. It's possible the 700 series all use the same rollers

http://www.searspartsdirect.com/partsdirect/brands-products/Asko-Parts/Dryer-Parts

Might want to give the a call

belt around the drum fell or broke off

hey to get the belt on the asko dryer you need to take all the screws out of the back of the dryer back plated dont worry you can do this take the top plate off 2 then remove the cap from the optional side vent pipe if applicable lay dryer on to the front side down position lift the back plat a littlew say 5 inches reach in and take the vent plastic manifiold out by pulling it right an inch or so then pull it toward you (back ) when you get it out you can see the motor wih the belt idler pintle (axle) if your belt idler has fallen loose locate it and or remove it temporarily figger out hay the idler fits to the belt onto the motor houseing (unit) pull belt off the drum towards you remove between the space between the back plate and dryer drum to preplace instale in reverse order note 1 wire you will need to reach into the bak at top to reatrtache the plastic clip so you can screw it up to keep it from rubbing ect and good luck

Hi,

How to install a belt on ASKO dryer
Belt Type: Flat belt with ribs
Installation Notes: Ribs go against drum



You could Refer to :-

http://fixitnow.com/wp/2006/05/08/asko-t700-dryer-wheel-drum-and-belt-replacement-instructions/

It would be a Generic one but would help you.

Let me know, if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101
.//////////////////////

yes you can get the inner door piece, check for a faulty hi-limit switch on heating element case or the cycling heat switch

I'll add the diagram that was inside my Asko T700 to the documents section.

Seems like you need new drum rollers. If one(or both) is bad, the drum will rub in the plastic.