Our copystar 2030 keeps asking for toner. We just replaced the old cartridge with a new one. We removed the tabs from the new cartridge and when we load it up the message says "adding toner" then stops and says "add toner". It will not print or copy either. Has anyone else had this error?
Can be an ensemble of the reasons:
1. The Silent sensor which checks the concentration of the toner.
2 Check pulled of you film defensive with tubas?
3 During moving the toner track can be broken or littered.
4 Can be a value-added degree to concentrations of the toner in service programme inflexion
5 Can be sensor itself to concentrations
7 Sensors can be littered
8 If it is used developer, can be violated concentration developer to toner
This in a complicated way repairs with words.Sooner whole you should apply to service,forgive, but such fault it is difficult do advice, it is necessary all look the experienced specialist, you may lose much toners and break the track of the presenting the toner, apply to service. Good luck
161 views
Usually answered in minutes!
Did you shake the toner cartridge well before fitting?Also is it a genuine toner cartridge?
×